-
14th February 2021, 04:14 PM
#1
Auto Hub Torque?
Wondering if anyone can help me out with the torque settings for the 6 big bolts that hold the auto hubs on??
2013 Y61 3L Manual
Thanks.
-
-
14th February 2021 04:14 PM
# ADS
Circuit advertisement
-
14th February 2021, 06:24 PM
#2
-
The Following User Says Thank You to MB For This Useful Post:
-
14th February 2021, 06:25 PM
#3
Patrol God
40ftlb or 56nm according to the manual.
-
The Following 2 Users Say Thank You to mudnut For This Useful Post:
10G (15th February 2021), MB (14th February 2021)
-
14th February 2021, 08:21 PM
#4
.........
-
The Following User Says Thank You to MB For This Useful Post:
-
15th February 2021, 09:30 AM
#5
Thanks guys, I appreciate the help.
I had a 1/2" to 3/8" adaptor coz I have a 3/8 allen key thingy like that MB. The adaptor split in two HAHAHA.
How tight should I do up the bearings?? They were a tad loose, I just tightened them up by hand using the 2 pronged socket, didn't use a ratchet/handle.
-
The Following User Says Thank You to 10G For This Useful Post:
-
15th February 2021, 11:16 AM
#6
Patrol God
The book says to really tighten the bearing to 145ftlbs - 167nm. Rotate the hub a few times in both directions. Loosen the nut to zero, then tighten to sweet bugger all, (3-5nm.) Turn the wheel again and do another 3-5nm. There is more to it but in the manual Pages FA4-6
Last edited by mudnut; 15th February 2021 at 11:22 AM.
-
The Following 2 Users Say Thank You to mudnut For This Useful Post:
10G (15th February 2021), MB (15th February 2021)
-
15th February 2021, 11:25 AM
#7
Originally Posted by
mudnut
The book says to really tighten the bearing to 145ftlbs - 167nm. Rotate the hub a few times in both directions. Loosen the nut to zero, then tighten to sweet bugger all, (3-5nm.) Turn the wheel again and do another 3-5nm. There is more to it but in the manual Pages FA4-6
Yeah, that is bugger all.
Out of the 4 small screws in the locking ring, 3 were stuffed, had to butcher some small screwdriver bits to get 'em out. Surprisingly I found 4 screws of the same thread, bloody miracle.
-
The Following 2 Users Say Thank You to 10G For This Useful Post:
MB (15th February 2021), mudnut (15th February 2021)