Powered Nutsert tool for the infrequent user

[PeeBee]

I was watching a YT vid of a guy using one and his method was to not use a clutch and allow the drill itself to start to twist from his hand. He’s obviously not holding the drill too tightly.

Probably a good idea to play with it on some scrap with the different types of rivnuts to see what works best with your own drill.

No problems, whatever works I guess. As soon as I say one method there will be 20 other ways to do it. The method I described is in the operating instructions, which by the way are crap. As a heads up, wind the tool in reverse, either by hand or in the drill until the treaded spindle is at a stop, bu the hex drive shaft. Then screw on the insert, and reverse the direction of the drill to lock the rivnut in place. I found a 0.5 - 1mm clearance was about right, and push the rivnut hard against the locking surface to stop it spinning - little 'findings' I noticed.