-
27th October 2017, 09:32 PM
#8021
Legendary
Originally Posted by
mudski
Rang the workshop and asked when I may see my Patrol again. Lol.
What's getting done? . .
Sent from my GT-I9506 using Tapatalk
-
-
27th October 2017 09:32 PM
# ADS
Circuit advertisement
-
27th October 2017, 09:52 PM
#8022
Originally Posted by
Rossco
What's getting done? . .
Sent from my GT-I9506 using Tapatalk
Its a bit sick. Tis' all I will say.
-
-
27th October 2017, 09:55 PM
#8023
Patrol God
Originally Posted by
mudski
Its a bit sick. Tis' all I will say.
did it find you'[re jacks satsh
Watch this space, as there maybe a comment added soon
-
The Following 2 Users Say Thank You to Avo For This Useful Post:
mudski (27th October 2017), Rossco (27th October 2017)
-
27th October 2017, 10:07 PM
#8024
Legendary
Originally Posted by
mudski
Its a bit sick. Tis' all I will say.
Hmm no good, hope it's better soon . . .
Sent from my GT-I9506 using Tapatalk
-
The Following User Says Thank You to Rossco For This Useful Post:
mudski (27th October 2017)
-
27th October 2017, 10:28 PM
#8025
Legendary
Originally Posted by
mudski
Rang the workshop and asked when I may see my Patrol again. Lol.
Sick.
Needing more power....
Sent from my A1601 using Tapatalk
12/97 GEE YOU
4.5lt Gas blower. Lots of mods to come.....all in good time.
-
-
27th October 2017, 10:47 PM
#8026
Originally Posted by
jay see
Sick.
Needing more power....
Sent from my A1601 using Tapatalk
Nah its got more than enough John.
-
The Following 2 Users Say Thank You to mudski For This Useful Post:
jay see (27th October 2017), Yeti's Beast (28th October 2017)
-
30th October 2017, 10:39 PM
#8027
Patrol Freak
ECU Post Refresh arrived back home today from ECPT. Put it in veh this arvo (08 CRD full NADS/3.1 Tonne not camped up) set max B to 21psi adjusting needle on the fly getting 6-7 psi drop @ 2500 RPM / 100ks cruise, good run so far thru varied drive states over an approx 100km run (good egts, good spool rate and pwr response). Very pleased so far more fine tuning to happen. John
2008 GU WAG ST Manual CRD - To do the job
-
-
2nd November 2017, 07:23 PM
#8028
Installed a higher performance fan than arrived home with after the trip into Burgoynes Gap crossing the McAlister River. The new one is an 8 blade genuine Toyota 3F motor fan, to replace the 7 blade after market Toyota 1HZ fan. 3F unit feels heavier and tougher.DSC01864.JPG
-
The Following User Says Thank You to PeeBee For This Useful Post:
-
2nd November 2017, 07:27 PM
#8029
Finished the pre straDSC01865.JPGDSC01866.JPGiner for the fuel tanks to take out the scale and rusty bits before they hit the booster pump and its pre filter. The strainer has a 100 micron filter screen, its a Scintex unit, cost $89 off ebay. Its fitted with a 12V heater band, 100w, for use one our snow trips only to stop the wax congealing, - yes even the fuel conditioner didn't help this last time. It mounts up under the floorpan between the two fuel tanks.
-
The Following User Says Thank You to PeeBee For This Useful Post:
-
2nd November 2017, 07:33 PM
#8030
Legendary
Adjusted the rear view mirror and it ended up on the floor , bugger !
-
The Following 3 Users Say Thank You to GQtdauto For This Useful Post:
jay see (5th November 2017), MB (2nd November 2017), PeeBee (2nd November 2017)