What did you do to your Patrol today!

[NissanGQ4.2]

Issue is you see beat up unroady shit boxes that shouldn't even be on the road with club reg driving daily

I see registered shit boxes that shouldn't be on the road daily, you guys probably have more 2 considering Vic doesn't have yearly inspections like we do here

[sooty_10]

I see registered shit boxes that shouldn't be on the road daily, you guys probably have more 2 considering Vic doesn't have yearly inspections like we do here

True.

Sent from my SM-G925I using Tapatalk

[taslucas]

You should check what gets around down here! Some works of art about for sure!

>>>tappin from tassie

[jay see]

That's pretty much Vic club rego. Log book and limited days. Issue is you see beat up unroady shit boxes that shouldn't even be on the road with club reg driving daily, exceeding any daily cap but just not filling in their logs.

Sent from my SM-G925I using Tapatalk

And because of those d!cks they will end up making it harder for the genuine bloke to take his ride out for a run.

Sent from my XT1068 using Tapatalk

[threedogs]

Plan is to change the steering damper ,,,
yeah right lets see how that pans out shall we lol
Had it over 6 mths already and its only a 10 min job lol

Didn't happen as I cant get under the Patrol, have to think
of another plan of attack GRrrrrrrrrr

[Toy-Eta]

Fitted the 3" exhaust today after work, unfortunately it was done in the driveway with a coupla work lights due to the troll being too tall for the shed out the back!

All good though, nice lil purrr

[Chappy]

After seeing the tablet setup @Winnie had a Licola I grabbed myself a tablet & ram mount setup. Chucked in a 64gb SD card, downloaded the Hema maps & got a Telstra 4g data share sim card that links to my phone data.

Awesome setup! Can't wait to test it out properly. Also, it doesn't bloke my vision for those wondering.

[sooty_10]

Had to go searching for this thread. No one must be doing anything.

Anyway I drove over my warn winch control several months back now. Plus my winch has been intermittent at best so I picked up this remote cheap on ebay.



Problem was its for a warn powerplant winch/compressor combo so the pin out was all wrong and it apparently has a thermal cutout. Well after scouring the web found a wiring diagram and eventually managed to suss out the correct pinout. Cut the old plug of my smashed controller and connected it to the new one. Works a bloody treat.

While I was at it I replaced my old 4 warn solenoids (most likely the intermittent issie) with an Albright solenoid.

I also swapped out the rear springs I had in with some lighter (HD) duty springs I had in the shed, it had xtra HD for a steel tray canopy ute. Hopefully she is a bit smoother over bumps now too.

Sent from my SM-G925I using Tapatalk

[jay see]

See your using your spare time efficiently.👍

Sent from my XT1068 using Tapatalk

[sooty_10]

See your using your spare time efficiently.👍

Sent from my XT1068 using Tapatalk

I'm now at a quiet branch and have actually started stock piling projects to complete during work hours too. Going to wire up my solar regulator and panel this week hopefully.

Sent from my SM-G925I using Tapatalk