What did you do to your Patrol today!

[MEGOMONSTER]

wouldn't rotating them at 5k do the same thing . I'm confused

Yes I have been regularly rotating tyres around but this time I also flipped the tyre on the rim.
So white writing on on the inside now instead of outside.

[Paule]

Fitted up some rated recovery points, I was wrapped, I didn't have to remove the alloy bar or anything, I had captive nuts on the passenger side and used the ones that hold the hook on the drivers side.

[mjr350]

After weeks of putting it off, I decided to hook my rear LED work light to the reverse light via a diode so it doesn't back feed to the reverse light when manually switched on via the switch on the centre console.
Great to finally see where I'm going in reverse.

[katwoman]

Fitted new HD king coils and new back brakes cos the old ones were down to metal. ( oops)

[Chappy]

Cut and rolled my guards for an extra 30mm of clearance.

IMG-20141129-WA0031.jpeg received_10152819341462521.jpeg.jpg

[MudRunnerTD]

Cut and rolled my guards for an extra 30mm of clearance.

IMG-20141129-WA0031.jpeg received_10152819341462521.jpeg.jpg

Good job. What did you use to roll them Jett?

[Chappy]

Good job. What did you use to roll them Jett?

Cheers mate, I'm really happy with the outcome. I used a heat gun to stop the paint from cracking and just used a small shifter and slowly worked my way around.

[Agronaught]

Completely rewired my radio setup in a bid to reduce engine noise on HF.

* ran LL200 in place of the crappy RG58/U coax.
* Moved the 2m/70cm antenna to the passenger side front bar, UHF CB is on the drivers side.
* Still using the Alinco DR-635T for UHF CB and Backup 2m/70cm... I really need to replace this unit though.

Testing a new HF setup:
* removed the RODA Screw Driver as it sits far too high on the spare tyre bracket and isn't allowed on the front bar.

Trialling new HF setup:
* Installed an Optek multi-tap antenna on the rear wheel bracket for HF. (tuned for 20m/14.200MHz)
* Installed LG-100 automatic antenna tuner on the Optek.
* Re-ran earthing lines to the tyre bracket, tuner and radio. I really need to buy a few meters of earthing braid :/

So far the results are promising.

Waiting on a quote from ministry of the interior for a roof console to fit the radio heads in...

[megatexture]

In the process of extending the front mounts and its giving me the shits I can only get 40mm out of it so may have to take 10 mm off the extentions grrr

[gaddy]

Swapped out the old sloppy efs 2inch springs , for new 2 inch kings (hardest they do ) gone from been a sloppy whale to a darting dart and picked up 45mm a corner in the process , happy as