-
13th November 2014, 05:08 AM
#4311
SPAMINATOR
Originally Posted by
mudski
Hairy muff! Thanks. Bit warm here tonight, a few too many beers makes me fuzzy.
I'll put a pic up of the two I didn't swap from the tnsfr and gearbox
IF YA DONT GET STUCK YA AINT TRYIN HARD ENOUGH........OR YA TOOK THE CHICKEN TRACK
WARNING: TOWBALLS USED WITH SNATCHSTRAPS DO KILL!!
-
-
13th November 2014 05:08 AM
# ADS
Circuit advertisement
-
13th November 2014, 07:13 AM
#4312
Patrol God
Originally Posted by
Patrol'n
Just replaced my console lid latch, so it doesn't bounce anymore, and installed my cup holder in the front console, hooray, now my drinks will stay put! Can't overstate how much better that is!
Did you make the cup holders or buy??
-
-
13th November 2014, 07:55 AM
#4313
Legendary
hey Kallen where did you get your front end bushes from??
was direct from Nissan or was there a cheaper supplier on Ebay for the same bush?
-
-
13th November 2014, 01:57 PM
#4314
Patrol God
All from patrolapart mate.
Radius bushes were ome and supplied with lift kit
-
The Following User Says Thank You to BigRAWesty For This Useful Post:
93patrol (13th November 2014)
-
13th November 2014, 05:20 PM
#4315
SPAMINATOR
-
The Following User Says Thank You to growler2058 For This Useful Post:
mudski (13th November 2014)
-
13th November 2014, 09:15 PM
#4316
Nifty little devices Growler.
-
The Following User Says Thank You to TazManiac For This Useful Post:
growler2058 (13th November 2014)
-
13th November 2014, 09:20 PM
#4317
Patrol God
Originally Posted by
growler2058
Here ya go Mudski you replace the old with the new the nylon tube then pushes into this self locking and there's an "O" ring internal to seal
What was the kit worth mate?
-
-
13th November 2014, 09:24 PM
#4318
SPAMINATOR
Originally Posted by
nissannewby
What was the kit worth mate?
Yeah mate it was $45 or $65 I think and was all done in less than an hour piss easy
IF YA DONT GET STUCK YA AINT TRYIN HARD ENOUGH........OR YA TOOK THE CHICKEN TRACK
WARNING: TOWBALLS USED WITH SNATCHSTRAPS DO KILL!!
-
-
13th November 2014, 09:30 PM
#4319
Originally Posted by
growler2058
Here ya go Mudski you replace the old with the new the nylon tube then pushes into this self locking and there's an "O" ring internal to seal
Ah I see why I was confused. I have different breather fittings on my diffs. I can't use those fittings.
-
-
13th November 2014, 09:53 PM
#4320
Packed the camper/ car for a weekend away
-