-
8th November 2011, 10:56 PM
#1
Advanced
crazy as death wobble
Ok now got to 86km/h and got mad as wobble and basically had to stop this is first time it has happened.
ok I've read bit bout it and sounds like panhard bushes need doin yea ? Wat else should I check and how can I check k thanks in advance
"Livin Large"
Gu dx Ute
A.K.A = ABBY
-
-
8th November 2011 10:56 PM
# ADS
Circuit advertisement
-
8th November 2011, 11:12 PM
#2
Simpson Desert
Check wheel bearings, swivel hub bearings, all tie rod ends, steering damper, radius arm bushes and wheel balance.
Get someone to swing the steering wheel back and forth while you're under the front of the car to check the tierod ends
for play.
Jack up the front of the car, try to wobble the wheels in and out, top to bottom and side to side to check for bearing
wear.
If it happened all of a sudden, check for thrown wheel weights.
-
The Following User Says Thank You to GUtsy ute For This Useful Post:
largey (9th November 2011)
-
8th November 2011, 11:28 PM
#3
Expert
What GUtsey ute said. might sound silly but, check the wheel nuts too.
Any work been done recently? If so, check that first.
-
The Following 2 Users Say Thank You to frenzy For This Useful Post:
GUtsy ute (8th November 2011), largey (9th November 2011)
-
9th November 2011, 02:52 PM
#4
Advanced
Have now checked over all bushes they all are new and seem ok have been told something with shims
"Livin Large"
Gu dx Ute
A.K.A = ABBY
-
-
9th November 2011, 05:00 PM
#5
Are your panhard bushes rubber or urethane?
Tony
-
-
10th November 2011, 02:25 PM
#6
Advanced
Ah there all genuine ah well sense it under warranty she goes into shop and they will be looking for fault and replacing parts
"Livin Large"
Gu dx Ute
A.K.A = ABBY
-
-
10th November 2011, 03:31 PM
#7
Advanced
i had the same problem in was the panhard bushes make shore thay r tight
-
-
13th November 2011, 11:13 AM
#8
Hi new to this was wondering if the panhard bushes would wear tyers uneven, have just had tie rod end done and new tyers put on and have had a wheel alignment as well. Have only done about 400 ks and the tyers look like they are wearing uneven. Thanks for anyone with information.
-
-
13th November 2011, 12:33 PM
#9
Originally Posted by
tsbrewer10@hotmail.com
Hi new to this was wondering if the panhard bushes would wear tyers uneven, have just had tie rod end done and new tyers put on and have had a wheel alignment as well. Have only done about 400 ks and the tyers look like they are wearing uneven. Thanks for anyone with information.
Possible but very unlikely, more likely the wheel alignment has not been adjusted correctly.
Tony
-
-
13th November 2011, 11:46 PM
#10
Patrol God
Originally Posted by
YNOT
Possible but very unlikely, more likely the wheel alignment has not been adjusted correctly.
Tony
I agree with Tony. some wheel aligners could't line up a crap into a dunny!
Tim
Getting Older Is Unavoidable, Growing Up Is Optional!
-