Clutch pedal bolt (the hard to get at one)

[Barrbeast]

Hey folks

Anyone know the size of the top bolt needed for a Y60 clutch pedal bracket?

I'm thinking M8 x 20mm or thereabouts?

(It's the one you have to dismantle half the dash to install/get at...)

[mudski]

I wouldn't think its 20mm. More like 12 or 14. This pin runs through two bushes also, which are probably no longer there, or partially....

[BrazilianY60]

So, are you talking about the clutch bracket to firewall bolts? Or clutch pedal to clutch bracket? The last one has some plastic/nylon bushings as Mudski has mentioned. Let us know which one you are talking about and I can maybe help with a picture or some measurements as I have one such pedal in a box around here, no need to take the whole Dash. :-)

[Barrbeast]

Thanks guys, should have said I'm doing an auto to manual conversion so I'm mounting a new clutch pedal where there's not been one previously but I forgot about that bolt until now!

It's the bolt that goes through the top of the pedal bracket itself and into a captive nut to secure the top of the bracket to the body of the truck.

[BrazilianY60]

Hi mate.
I have checked here, and honestly, I could not figure out what bolt is that one. What holds the clutch pedal bracket assembly to the firewall are the 4 studs of the clutch vacuum booster, so from inside, what you have is just 4 nuts, none are captive (the studs are captive on the booster).

My car is LHD but I don't see a reason for this to be different.

[Barrbeast]

Hi bud

Thank's for looking, it's definitely there but the heater duct will be in the way (that's why you have to dismantle some of the dash to fit it).

It's a bolt that goes through the top of the clutch pedal bracket (above the pedal pivot point) and into a captive nut in the body.

Part 0811681647 on the diagram, there's one in the same spot on the brake pedal as well.

Capture.JPG

[BrazilianY60]

Ok, so its one that goes upward.





The one I have here is a 12 mm with the following lenth and thread:

[Barrbeast]

Ok, so its one that goes upward.





The one I have here is a 12 mm with the following lenth and thread:

Absolute superstar, thank you so much dude!

Yeh M8 x 20ish if you include the non threaded part (occasionally I get it right &#128517

[Brissieboy]

FYI
As @Barrbeast has done, the proper way to measure a hex head bolt is:bolt.JPG

[BrazilianY60]

Thanks Brissie, living and learning, always!

Cheers mate!