-
4th June 2023, 11:32 AM
#21
Here is the latest update. Finally got to the point of a permit and a test drive. Got some high egts to resolve yet. Pump timing tool on order as I know that's probs not right. Hopefully didn't buy too big of a turbo as it's reverse scroll and limited options
20230516_163808.jpg20230517_145453.jpg20230517_145502.jpg20230519_115313.jpg20230308_173801.jpg
-
The Following 4 Users Say Thank You to overlandh1978 For This Useful Post:
10G (5th June 2023), MB (4th June 2023), PeeBee (4th June 2023), Rossco (4th June 2023)
-
4th June 2023 11:32 AM
# ADS
Circuit advertisement
-
4th June 2023, 04:42 PM
#22
I like what you have done with the rear quarter panel box and guard over the tires. Who's box, length and the guard as well? I am up to this part in my conversion but yours looks just what i need i think. Also where did you source the rubber blocks half way along the guards to no doubt support the edges of the bonnet?
Last edited by PeeBee; 4th June 2023 at 06:26 PM.
-
-
4th June 2023, 05:03 PM
#23
Bare body pre mask.jpgMasked up for undercoat.jpgSide elevation.JPGHere is mine, getting ndercoated Tuesday I believe, then Nissan Metallic Charcoal in 3 weeks.
-
The Following 4 Users Say Thank You to PeeBee For This Useful Post:
10G (5th June 2023), MB (4th June 2023), Rossco (4th June 2023), Winnie (4th June 2023)
-
4th June 2023, 06:06 PM
#24
.........
-
The Following User Says Thank You to MB For This Useful Post:
-
4th June 2023, 07:04 PM
#25
Bonnet blocks from patrolapart. Genuine ones. Boxes and guards from MW Toolbox. They are the 750mm ones. The guards from the same mob they were double sided I just cut to length
-
The Following 2 Users Say Thank You to overlandh1978 For This Useful Post:
MB (4th June 2023), PeeBee (4th June 2023)
-
4th June 2023, 07:07 PM
#26
Originally Posted by
MB
Alot of careful measuring went into that! I'm a performance petrol man mostly but I have rebuild a few td42s. Every time poor air flow damage is present. To me it was wildly apparent! I refuse to even use the common style high dollar RB intakes. I've not got it wrong in 18 years
-
The Following 2 Users Say Thank You to overlandh1978 For This Useful Post:
MB (4th June 2023), PeeBee (4th June 2023)
-
4th June 2023, 07:58 PM
#27
.........
-
-
4th June 2023, 08:24 PM
#28
I'm not at all fussed mate. I just play around in my machine shop. I built both manifolds as well as spent considerable time in the cylinder head20221223_135204.jpg20221223_135216.jpg20221119_163721.jpg20221017_141743.jpg
-
The Following 5 Users Say Thank You to overlandh1978 For This Useful Post:
10G (5th June 2023), MB (5th June 2023), MB TD42 (19th July 2023), PeeBee (4th June 2023), Rossco (4th June 2023)