-
11th October 2020, 06:18 PM
#1
Trouble separating cv joint from axle
Hi all! i have broke the end off the front right axle on the gu ute and i have a spare left hand side complete axle assembly. I am trying to separate the birfield joint from the axle so i can use the good one from left side on the right side, question is can this be done and if so can someone tell me how to achieve this. Thanks Badger
-
-
11th October 2020 06:18 PM
# ADS
Circuit advertisement
-
11th October 2020, 08:07 PM
#2
Moderator
Get a bigger Hammer. I have only done it once and it was a tough gig mate. I would 100% chase a whole short side replacement. I car a spare set of long and short side all greased and bagged zip tied to the bottom of the cargo barrier
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!
....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy -->
MudRunnerTD's GQ From the Ground Up
Originally Posted by
Rogue Dung Beetle
Wish it was Nissan though, Toyotas just can't keep up with the Pootrol pace.
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
-
The Following User Says Thank You to MudRunnerTD For This Useful Post:
mudski (13th October 2020)
-
13th October 2020, 09:43 PM
#3
I thought there was an internal circlip holding the shaft in as well???? I have a spare CV and shaft but never bothered to look at it.
Sent from my iPhone using Tapatalk
-