-
1st October 2020, 07:30 PM
#1
Advanced
MAF Sensor bolt size
G'day everyone,
I managed to over tighten one of the bolts when putting the maf back in my '09 Trol, being in Melbourne I can't go anywhere to measure the other one up for size.
Can someone please tell me the size of these little buggers?
Cheers
Brad
-
-
1st October 2020 07:30 PM
# ADS
Circuit advertisement
-
1st October 2020, 08:48 PM
#2
Patrol Freak
Measured stock (OEM) Torx M4 x 0.7mm pitch (pitch best guess with vernier) out of CRD MAF stock housing. Effective length thread 10mm / overall length under head 12mm (stainless steel would be choice).
Unbraco, Cap hd screw aso would be fine.
Did you shear fastener or strip thread in plastic housing?
2008 GU WAG ST Manual CRD - To do the job
-
The Following User Says Thank You to Bidja For This Useful Post:
Mcflurry (1st October 2020)
-
1st October 2020, 08:53 PM
#3
Advanced
You're a legend thanks Bidja
The bolt snapped in half as I was winding it in. I clean it far too often (every service) so those little fellas get plenty of work
-
The Following User Says Thank You to Mcflurry For This Useful Post: