Short drill bit set

[PeeBee]

I bought a right angle drill, but to get the most use out of it, I am looking for a set of short drill bits say from 2mm to 13mm in diameter. The drill needs the unfluted shank in the chuck, but I can't find a set anywhere. Chime in if you know where I can source them -i have tried Total Tools and ebay - nothing.

[PeeBee]

Bugger me, next page on ebay

https://www.ebay.com.au/itm/1-13mm13...a8cd6c094ab40d

[rusty_nail]

I bought a right angle drill, but to get the most use out of it, I am looking for a set of short drill bits say from 2mm to 13mm in diameter. The drill needs the unfluted shank in the chuck, but I can't find a set anywhere. Chime in if you know where I can source them -i have tried Total Tools and ebay - nothing.

why dont you buy a drill bit set and cut themn to the length you need?

[PeeBee]

why dont you buy a drill bit set and cut themn to the length you need?

I need the unfluted section, and to be honest, cannot be stuffed cutting the end off the flute then reforming it 12 times!

[PeeBee]

OK, think these will do.

https://www.ebay.com.au/itm/DRILL-BI...r=424333591344

[mudnut]

Glad you found some. I could've sent you all my broken bits, Phil