G’day NP.com.au good folks!
Honest nuffy question, how does one tell/identify their diesel injector pump stock sizes?
Sent from my iPhone using Tapatalk
G’day NP.com.au good folks!
Honest nuffy question, how does one tell/identify their diesel injector pump stock sizes?
Sent from my iPhone using Tapatalk
Part number might help determine which is which
The Ti pump has an electrical plug at the bottom of the pump, the bracket to hold the back of the pump is also different, it has a relief cast into it to suit the plug
Just another Blue over Silver GQ with another TD conversion
MB (8th July 2019)
Cheers Dave Mate!
Personally/thankfully never needed to ring them (Nissan) to date, is there a number somewhere on their stock castings maybe?
Sent from my iPhone using Tapatalk
MB (9th July 2019)
Assuming the vehicle is unmodified in that department from new, would the VIN be sufficient to enquire with Nissan?
MB (9th July 2019)
As far as I know, all GQ use 10mm, GU N/A and factory turbo use 10mm and only the factory Turbo intercooled models use 11mm. 12mm is an aftermarket option.
MB (9th July 2019)
MB (10th July 2019)
Thanks Gents, appreciated!
Rang Nissan with the VIN and only got a part number: 16700VB920
Being a stock rocket TD42T it must only be a 10mm then thanks @mudski mate!
Sent from my iPhone using Tapatalk
Not sure why you were asking but for your info mate, when i spoke too ufi about getting a pump built they said there's no difference in performance compared to plunger size. As in, a pump setup for 200hp in 11mm won't show any difference to a 12mm setup the same on a dyno. 12mm is only needed when shooting higher than the 11mm will allow.
2003 GU TD42 with a few extra ponies
MB (9th July 2019)