OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

User Tag List

Results 1 to 2 of 2

Thread: How to ,remove electrical connector from IP

  1. #1
    Advanced
    Join Date
    Jan 2017
    Posts
    42
    Thanks
    5
    Thanked 8 Times in 7 Posts
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    How to ,remove electrical connector from IP

    Zd30 engine wont start
    Tried to remove connector from IP so i can test # 7 for voltage.
    How does this plug come off. I see a 20mm x 40mm grey plastic part that i can slide out towards me 20 or 30mm as im hanging over the guard. [some sort of locking devise, i think]
    Not sure what to try next , any ideas thanks

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many

     

  3. #2
    Advanced
    Join Date
    Jan 2017
    Posts
    42
    Thanks
    5
    Thanked 8 Times in 7 Posts
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Some joy, apparently i didnt have the slide release quite far enough out, once i got it the plug removed rearwards easily.
    Plug connfiguration was a little different to the one shown in the manual. similar but 6 connectors Vs [9 in manual]
    connector that would have been closest to me and on the bottom gave me 12.6v and the one above it went to ground. So i think thats ok, starting to worry its the pump.

  4. The Following User Says Thank You to Dagwill For This Useful Post:

    MudRunnerTD (30th June 2019)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •