Tools you have bought/want to buy feedback thread

[10G]

Thanks for that info, appreciate the help.

[PeeBee]

Thanks for that info, appreciate the help.

Not a problem. Let us know what you find out if you start chasing from your end.

[Seluntiy]

And here you can only write about the tool that you bought or you can show the tool that you made yourself?

[Seluntiy]

I made a sandblast out of an old freon cylinder.

[10G]

finally after decades got one of these. wanted one before I could weld, then I could weld so just welded nuts onto stuff, but the time came ...

20201118_140155.jpg

[Mickhead]

8C05ACC2-05C5-4B07-A0B7-52CC9BC76CCF.jpeg

finally after decades got one of these. wanted one before I could weld, then I could weld so just welded nuts onto stuff, but the time came ...

20201118_140155.jpg

Now get these! 😀

[MB]

RivNuts/NutSerts rock you’ll love em
Just be a wee bit careful on the high quality 304HC stainless ones, the Kinchrome tool kit may break a handle if your hole size isn’t exactly to spec or slightly greater as they’re a lot tougher them stainless ripper serts Mick kindly suggested
We cheat with playgrounds, pneumatic guns


Sent from my iPhone using Tapatalk

[Mickhead]

RivNuts/NutSerts rock you’ll love em
Just be a wee bit careful on the high quality 304HC stainless ones, the Kinchrome tool kit may break a handle if your hole size isn’t exactly to spec or slightly greater as they’re a lot tougher them stainless ripper serts Mick kindly suggested
We cheat with playgrounds, pneumatic guns
Sent from my iPhone using Tapatalk

Ho lee chit mr Mark. I only broke the mandrel on mine ������561238DA-3F5D-4550-98DC-793392CB7574.jpeg

(Special order for about 13 bucks from bunnings if you do strip one of these)

[MB]

Crikey, that’s a bargain Mick
TBH, our pneumatic work guns are so temperamental tuning in, thinking about going some Kinchrome’s too for on-site needs.
FWIW: Back in the olden days We used simply a bolt/nut/washer/grease/washer then our RivNuts at the end of line.
Hold the bolt hard with Vicegrippies and Shifter crank the top nut down compressing the RivNut to death, slow and sucks but works


Sent from my iPhone using Tapatalk

[Mickhead]

Crikey, that’s a bargain Mick
TBH, our pneumatic work guns are so temperamental tuning in, thinking about going some Kinchrome’s too for on-site needs.
FWIW: Back in the olden days We used simply a bolt/nut/washer/grease/washer then our RivNuts at the end of line.
Hold the bolt hard with Vicegrippies and Shifter crank the top nut down compressing the RivNut to death, slow and sucks but works

Sent from my iPhone using Tapatalk

Sorry that 13 bucks is for the replacement stripped mandrel