-
1st June 2020, 07:54 PM
#361
Originally Posted by
nissannewby
Is the bolt broken below the surface of the thread?
If it's not then just weld a nut to it and undo it. Even if its snapped flush you can still weld something to it.
The image from the camera has it flush with the block, but I will see tomorrow morning when I get the plates apart.
-
-
1st June 2020 07:54 PM
# ADS
Circuit advertisement
-
1st June 2020, 07:56 PM
#362
Good points Darren, I asked about the 240V corded versions and they were close to $700 each! I am sure it will get used, but they were all around this 280-325 mark, so just went with the brand i had batteries for.
-
The Following User Says Thank You to PeeBee For This Useful Post:
MudRunnerTD (1st June 2020)
-
1st June 2020, 08:44 PM
#363
The 747
They are great for tradies doing rough ins on new houses!
Sent from my SM-G986B using Tapatalk
-
The Following User Says Thank You to Winnie For This Useful Post:
-
3rd June 2020, 03:23 PM
#364
-
The Following 3 Users Say Thank You to Cremulator For This Useful Post:
0-TJ-0 (3rd June 2020), PeeBee (3rd June 2020), rusty_nail (3rd June 2020)
-
4th June 2020, 09:28 PM
#365
Daily Lurker
Just seen this circ saw on Maine cabin masters!!! What a bloody beast! For those not Familiar with stupid imperial, the blade diameter is over 413mm!!!
Sent from my SM-G965F using Tapatalk
-
-
4th June 2020, 09:37 PM
#366
Breadmaker Shaker
Originally Posted by
rusty_nail
Just seen this circ saw on Maine cabin masters!!! What a bloody beast! For those not Familiar with stupid imperial, the blade diameter is over 413mm!!!
Sent from my SM-G965F using Tapatalk
What would be the cutting depth on that one nicco?
What is the charge? Eating a meal? A succulent Chinese meal??
-
-
4th June 2020, 09:38 PM
#367
Daily Lurker
Probably around 180mm? I reckon it would still cut deeper than a 12" dropsaw
Sent from my SM-G965F using Tapatalk
-
-
4th June 2020, 09:39 PM
#368
Breadmaker Shaker
Would wanna be Japanese Makita too, not from the chinese division.
What is the charge? Eating a meal? A succulent Chinese meal??
-
The Following User Says Thank You to Plasnart For This Useful Post:
rusty_nail (4th June 2020)
-
4th June 2020, 09:45 PM
#369
Daily Lurker
Originally Posted by
Plasnart
Would wanna be Japanese Makita too, not from the chinese division.
They have stuff mate in England too! My 18v planer is English made. The Japanese stuff is definitely better quality than the Chinese tools
Sent from my SM-G965F using Tapatalk
-
-
4th June 2020, 09:56 PM
#370
Breadmaker Shaker
Originally Posted by
rusty_nail
They have stuff mate in England too! My 18v planer is English made. The Japanese stuff is definitely better quality than the Chinese tools
Sent from my SM-G965F using Tapatalk
Wow didn't know about the pommy factory. Have always preferred makita tools, and when i bought the rattle gun a few years ago I had to be particular. The good from Nippon. The not-so-good from Bat Soup central.
What is the charge? Eating a meal? A succulent Chinese meal??
-