-
18th October 2018, 09:54 AM
#1
how to service these grease points. image provided
hi
i recently got some swaybar links and they have a grease point ive not seen before.
i thought i could un thread them and put in a m6 grease nipple but these arent even threaded they are a push in fitting.
i pulled one out and its diameter is so small id have to drill out the part and tap it for a m6 grease nipple.
other thought is to pull out the fitting and use a grease needle but i dont think itll work, probably make a mess as the grease wont be forced into the rose joint.
my question is, is there a tool designed to service this style of grease fitting?
Capture.JPG
-
-
18th October 2018 09:54 AM
# ADS
Circuit advertisement
-
18th October 2018, 03:42 PM
#2
I think you use one of these.
https://www.stm.net.au/grease-equipm...tor-needle-tip
I have seen those before but never really thought how to get grease into them.
More of them here....
https://www.stm.net.au/grease-equipment/15/1/4/
-
-
18th October 2018, 04:00 PM
#3
yeh that might work, may even have to pull the cap out to do it
-