-
14th May 2011, 10:41 AM
#51
Banned
Originally Posted by
toddrhind
This was done 10 years ago.... could of been longer, can't remember the actual date! And it was necessary 2 do it at the time
It's ALWAYS necessary!!! That's what I keep telling the missus every time I do something to Tank ... especially if it costs money!!!! LOL
-
-
14th May 2011 10:41 AM
# ADS
Circuit advertisement
-
14th May 2011, 12:28 PM
#52
Legendary
Originally Posted by
Bigrig
Surely it's been done before!! LOL
No more lantana linework from the bush tracks! No more having to wash it ever! These are all good reasons .... surely!!! lmfao
I would say someone must of, tempting isn't it! LOL
Qualified Auto-Electrician
Apprentice Sparky
Dont own a Patrol or any 4WD at the moment, hopefully will change into the future
-
-
14th May 2011, 01:03 PM
#53
SPAMINATOR
-
-
14th May 2011, 01:28 PM
#54
Banned
Originally Posted by
growlers71gq
OK a bit of folding action! i put stick tape back on and drew myself a line where i want the fold to be. I cut the tabs as close to the line as my nervous hand would allow. I cut a wedge out 1 side of each tab to help with folding. I chose to use multi grips and little bends at a time. Small duck bill pliers or vice grips may do better. This part of the job may well be left to a panel dude but i rekon a slight hammer tapping and a scrape of bog will get the edge nice n straight again. Or it may get hidden by new barwork to, i'm not too concerned next job will be rust proof before placing the infills in, i cut them outa a old sign. So far the jobs cost 3 small angle grinder discs!
STOP!!! you don't do that!!!
Nahhh ... just jokes! Like I have a clue!!! lmfao
It's getting there bloke, doing well!!!
-