OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

User Tag List

Results 1 to 10 of 17

Thread: Fitting Rear Coil Braces AAARRGGGHH

Threaded View

  1. 3rd February 2018, 09:15 PM #8
    MudRunnerTD
    MudRunnerTD is offline
    Moderator MudRunnerTD's Avatar
    Join Date
    Jun 2010
    Location
    Geelong
    Posts
    15,406
    Thanks
    12,206
    Thanked 13,523 Times in 6,609 Posts
    Mentioned
    330 Post(s)
    Tagged
    1 Thread(s)
    Quote Originally Posted by mudnut View Post
    Obvious questions, but how did you go bending the tower back to its original form? Is it dead level? How much space is there between the tower, fuel lines and body? You might want to check that the body mounts aren't munted.
    My drivers side tower was in very ordinary condition.

    My tower was touching the floor. I used a 6ft crow bar from the passenger side and a jack. Worked a bloody treat!! That was actually what I expected to be the hardest bit. The welding was a Dog!!!!!!



    Sent from my SM-G955F using Tapatalk
    Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!! ....... I'm a lucky bugger! I've got 2 of em!
    Check out my Toy --> MudRunnerTD's GQ From the Ground Up

    Quote Originally Posted by Rogue Dung Beetle View Post
    Wish it was Nissan though, Toyotas just can't keep up with the Pootrol pace.
    The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
    WARNING: Towballs used for recoveries can, and do kill people and damage property.
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to MudRunnerTD For This Useful Post:

    mudnut (3rd February 2018)
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules