-
14th December 2017, 12:51 PM
#31
Patrol God
Did you apply a bit of multi-purpose grease to the push pin and the sliding surface on the dust seal at the master cylinder? There must be air and crud in the slave cylinder for it to be getting stuck. Download the manual and have a look at the clutch section so you can see how it all goes back together
My advice is: not to follow my advice.
-
The Following User Says Thank You to mudnut For This Useful Post:
Bidja (14th December 2017)
-
14th December 2017 12:51 PM
# ADS
Circuit advertisement
-
14th December 2017, 06:22 PM
#32
you didn't shake the brake fluid bottle before you topped up the master cyl reserve did you. if you did this can airate the fluid and can take a while to settle and bleed out.
-