-
20th November 2016, 03:25 PM
#1
Patrol Guru
UHF Power Adpater
Hi All,
I had a Uniden UHF thats been playing up so replacing it with an ICOM. The power from the uniden was rectangular 3 pin with only 2 in use
IMG_1977.JPG
IMG_1978.JPG
This is the ICOM supplied Power lead
IMG_1979.JPG
Anyone know if you can get adapters so I don't have to replace the existing power cable?
Cheers
Fish
2004 4.2TDi GU ST Ute, 3" Exhaust, UHF, Lightforce Spotties, BFG All Terrains, Steel Winchbar, Winch, Dual Batts, CC Ultimate IC, 4" Snorkel, XLR8 Steps and Scrub bar
-
-
20th November 2016 03:25 PM
# ADS
Circuit advertisement
-
20th November 2016, 04:07 PM
#2
Patrol God
You could try JayCar they have all kinds of plug ends.
its only pos and neg so you could buy a new set
dont forget to fuse it
Last edited by threedogs; 20th November 2016 at 04:09 PM.
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
-
The Following User Says Thank You to threedogs For This Useful Post:
gubigfish (20th November 2016)
-
20th November 2016, 04:10 PM
#3
Rotaredom
Just cut the Uniden plug off and join the new plug? Easier than trying to source any type of adapters
Time is never wasted when your wasted all the time
WARNING: Towballs used for recoveries can, and do kill people and damage property.
-
The Following User Says Thank You to NissanGQ4.2 For This Useful Post:
gubigfish (20th November 2016)
-
20th November 2016, 05:13 PM
#4
Patrol Guru
Was trying to avoid cutting the supplied cable. Found both types of connector at Jaycar for anyone else looking to do this in future.
2004 4.2TDi GU ST Ute, 3" Exhaust, UHF, Lightforce Spotties, BFG All Terrains, Steel Winchbar, Winch, Dual Batts, CC Ultimate IC, 4" Snorkel, XLR8 Steps and Scrub bar
-
The Following User Says Thank You to gubigfish For This Useful Post:
NissanGQ4.2 (20th November 2016)
-
2nd December 2016, 09:23 AM
#5
The Icom connector is a bit more substantial than the Uniden, the cable looks heavier, it is probably worth the effort to rewire & eliminate any possible faults. Adapters are not a good permanent solution.
If you cut the Uniden connector off you can use the old wire to pull the new one back through the firewall, I would use a relay to switch power on when ignition is on.
Graham
-