-
3rd June 2016, 10:25 AM
#41
Patrol God
Bugger..
What a pain..
Sorry mate.
-
-
3rd June 2016 10:25 AM
# ADS
Circuit advertisement
-
3rd June 2016, 10:57 AM
#42
Advanced
Its all good mate. Always up for a learning experience, I will just have to figure out a better way of attaching the magnets to the tail shaft. Better than the double sided tape that came in the kit
Sent from my SM-G900I using Tapatalk
-
-
3rd June 2016, 11:16 AM
#43
Patrol God
Not 100% sure but on the RR years ago I think my mate used
some sparky tape on the outside then some aircraft lock wire.
It never moved from what I know
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
-
-
3rd June 2016, 11:20 AM
#44
Advanced
Now that you say that TD there is a small coil of wire that come in the kit and little tabs on the magnets that would fit the wire perfectly! Cant belive I didnt realize thats what it was for!
Doh! (Smacks self on the forehead)
Sent from my SM-G900I using Tapatalk
-
The Following 2 Users Say Thank You to Dannyboyz For This Useful Post:
BigRAWesty (3rd June 2016), threedogs (3rd June 2016)
-
3rd June 2016, 11:31 AM
#45
Patrol Guru
I think the AP300 might be speed sensor compatible? Can anyone confirm that? It is a dearer setup though.
Sent from my SM-G925I using Tapatalk
-
-
3rd June 2016, 10:39 PM
#46
Advanced
Woo hoo, road test complete with magnet on drive shaft. All working perfectly. Sits on its speed like a dream, didnt take it past 104 but im sure it will go faster, thats about as fast as I'm gunna cruise at anyway. Thanks to everyone who offered help and advice and I hope this thread will help someone else in the future. NT here we come!
Sent from my SM-G900I using Tapatalk
-
The Following 2 Users Say Thank You to Dannyboyz For This Useful Post:
BigRAWesty (3rd June 2016), Stropp (4th June 2016)
-
3rd June 2016, 11:37 PM
#47
Patrol God
-
-
22nd June 2017, 01:25 PM
#48
Originally Posted by
Dannyboyz
Ok sorry guys, phone had a nasty accident yesterday so couldnt get in for the update, official word from Command is I will have to put magnets on. Pulse is too fast out of my factory speed sensor
Sent from my SM-G900I using Tapatalk
I am installing a Command AP60B, and with one magnet on and the loop wire cut, it would only work above 80kph. I spoke to command and they said I could use the built in speed sensor cable instead of magnets (or add an extra magnet). Not sure how that gels with Dannyboyz' experience with the pulses being too fast and command saying go to magnets!!
-