-
24th October 2015, 09:43 AM
#11
Advanced
Well that worked out alright westy, old man has a couple GU and he's going to buy 2 locking sliders off me. Get a set of drawers made for himself. So now I'll order 2 none locking ones. Covered me there, thinking it would be a bugger with two locking on each draw
-
The Following User Says Thank You to Phill265 For This Useful Post:
BigRAWesty (24th October 2015)
-
24th October 2015 09:43 AM
# ADS
Circuit advertisement
-
24th October 2015, 09:58 AM
#12
Advanced
Well progress so far, pulled carpet out. Painted the floor with white kill rust, and put silicon in all the unwanted holes. Punch 6 holes in carpet for slates and brought longer bolts to go through slates into existing bolt holes.
Sent from my iPhone using Tapatalk
-
The Following User Says Thank You to Phill265 For This Useful Post:
BigRAWesty (24th October 2015)
-
24th October 2015, 10:10 AM
#13
Patrol God
Originally Posted by
Phill265
Well that worked out alright westy, old man has a couple GU and he's going to buy 2 locking sliders off me. Get a set of drawers made for himself. So now I'll order 2 none locking ones. Covered me there, thinking it would be a bugger with two locking on each draw
Yea I built my self and father inlaw a slide for our cf50's and hind site should have only bought 2 locking instead of 4..
It's just a pita with to..
-
-
24th October 2015, 10:38 AM
#14
Advanced
Yeah just a bugger lifting two up, and trying to get the drawer out.
-
-
24th October 2015, 10:45 AM
#15
Advanced
Next up cut 6 slates of 12mm ply at 30mm wide. Glued 2 together to make 3. Trimmed the one just behind the seat to make lvl, then added a small block in the centre of it for support.
Sent from my iPhone using Tapatalk
-
-
24th October 2015, 10:49 AM
#16
Advanced
Cut floor to size, then drilled holes round bolts for easy access
Sent from my iPhone using Tapatalk
-
-
24th October 2015, 11:05 AM
#17
Advanced
With the bench saw cut a 6mm x 13mm recessed edge on top and bottom. Made a couple square edges, with holes to clap square with, glued and screwed together
Sent from my iPhone using Tapatalk
-
The Following User Says Thank You to Phill265 For This Useful Post:
BigRAWesty (24th October 2015)
-
20th October 2016, 10:44 AM
#18
Advanced
screw runners in went with one locking one, and one non locking slide per draw as suggested.
Sent from my iPhone using Tapatalk
-
-
20th October 2016, 10:52 AM
#19
Advanced
boxed the drawers and screwed them to runners
Sent from my iPhone using Tapatalk
-
The Following User Says Thank You to Phill265 For This Useful Post:
DX grunt (20th October 2016)
-
20th October 2016, 11:04 AM
#20
Advanced
-