Hi all. Have a uniden din size uhf. Having issues that when receiving incoming transmissions i get continuous static coming through. I can only stop the static by tapping my handset button. Any ideas?
Hi all. Have a uniden din size uhf. Having issues that when receiving incoming transmissions i get continuous static coming through. I can only stop the static by tapping my handset button. Any ideas?
Do you have a squelch button, may also be loose wire
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
Does have a squelch button which I've played with. No luck. Only seems to happen when close to the person traveling.
The 40 channel and 80 channel dont like talking to each other. Maybe thats it.
KATROL- The 2nd
GU TD42TGi
Not as pretty, but a whole lot tougher
Silent member 1208
Yes Michael, I bought a JEE.....60.
katwoman (17th June 2015)
I had a 80 channel and couldn't be heard by the 40 channel radios unless I put the mic close (less than 50mm) to my mouth, got fed up with it and had the old 40 repaired then reinstalled it in the car.
Spoke to a GME rep and he said it was a problem and there is no fix for it.
Kat, it's not just you.
Cheers
Macca
katwoman (12th June 2016)
It wont be the differance betwen the 40 / 80 channel rigs as long as they are on the same channel. (and between channels 1 - 40)
40 - channel reciveing a transmission from an 80 channel - the recived audio is lower
80 - channel reciveing a transmission from an 40 channel - the recived audio is higher, worst case you could get some audio blocking (bit of no audio). But most of the cbs are desiggned to prevent this.
How i it transmiting? do you have good range - can others hear you a km away? - as you might have a staffed antenna / cable / connector (most often a connector fault).
When you tap the button and stop the static, do you then hear ok?
Or are you activating the tranmitter?
1991 GQ LWB 4.2 Carby dual fuel, 32 mud claws, 2 inch lift, LSD's front and back
And its Toooooooo High for the Ball & chain
katwoman (21st June 2015)