Rear swing away options

[BigRAWesty]

Got some "steam pipe", ran a 35mm holesaw then sand paper on a stick in the drill to clean the seam weld.

Worked a treat.

The bushes are the same as the rear springs on mine are so have some emergency spares!

Worked a treat.

Great to hear

[macca]

Got the last bits and finished it completely.

Works as it should, added a little strengthening where others suggested at last night's club meeting. New eyes gave good advice.

Very happy.

Now the pod is empty, LOL

[threedogs]

I may be just me but I would put the bolt through from the top as if nut falls off bolt remains '
thats if, the way it is now if nut falls off bolt will fall out and thats that.
Other than that it looks the goods

[macca]

I may be just me but I would put the bolt through from the top as if nut falls off bolt remains '
thats if, the way it is now if nut falls off bolt will fall out and thats that.
Other than that it looks the goods

There is a bit of a plate on the bolt "head" not seen in the photo. Its silver and is just visible.

If it was to fall out the angle iron bracket fixing bolts stop it from falling out.

Cheers for looking out for me LOL

[Stropp]

nice job Macca, looks nice and sturdy.

[macca]

There's a better photo TD