OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

User Tag List

Page 4 of 4 FirstFirst ... 234
Results 31 to 31 of 31

Thread: DIY winch cradle for GU alloy bar.

  1. #31
    Beginner
    Join Date
    Jun 2016
    Location
    Fraser Coast QLD
    Posts
    29
    Thanks
    12
    Thanked 9 Times in 8 Posts
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Sorry to tickle an old thread but better than starting a new one, I used the straight across 8mm plate on my GU, but to run my dyneema straight out from the plate I cut a slot where the number plate usually sits. Is there any advantage or disadvantage on pull stress noticable depending on the angle it comes through the bar? 20160609_122840.jpg

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Location
    Advertising world
    Posts
    Many

     

Page 4 of 4 FirstFirst ... 234

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •