OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

User Tag List

Results 1 to 10 of 187

Thread: DIY CV and Swivel Hub Rebuild Thread

Threaded View

  1. 19th July 2014, 10:27 PM #11
    MudRunnerTD
    MudRunnerTD is offline
    Moderator MudRunnerTD's Avatar
    Join Date
    Jun 2010
    Location
    Geelong
    Posts
    15,394
    Thanks
    12,188
    Thanked 13,507 Times in 6,602 Posts
    Mentioned
    330 Post(s)
    Tagged
    1 Thread(s)
    Getting excited now folks!!! its all going back together.

    Disk On



    install the washer



    First nut



    then tension the Hub Nut up to 145ft/lb and turn the disk both ways to work the grease and take up the slack.







    Then undo the nut to zero tension, respin the disk and retighten to factory spec 3.6ft/lb (near hand tight).
    Last edited by MudRunnerTD; 19th July 2014 at 11:17 PM.
    Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!! ....... I'm a lucky bugger! I've got 2 of em!
    Check out my Toy --> MudRunnerTD's GQ From the Ground Up

    Quote Originally Posted by Rogue Dung Beetle View Post
    Wish it was Nissan though, Toyotas just can't keep up with the Pootrol pace.
    The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
    WARNING: Towballs used for recoveries can, and do kill people and damage property.
    Reply With Quote Reply With Quote

  2. The Following 8 Users Say Thank You to MudRunnerTD For This Useful Post:

    10G (25th March 2024), Conradk (31st October 2014), graeme1969 (20th July 2014), NissanGQ4.2 (20th July 2014), Parksy (20th July 2014), Tanker (4th May 2015), Warwick89 (13th October 2014), Wine_maker (4th February 2018)
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules