I have a also embedded the above post into post 5 of this thread where it should be in the process. Hope it helps gent.
I have a also embedded the above post into post 5 of this thread where it should be in the process. Hope it helps gent.
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
Clunk (27th March 2019), Plasnart (27th March 2019), rusty_nail (27th March 2019)
Cracker write up, helped out heaps!
MudRunnerTD (16th June 2019)
Great write up, thank you MudRunner. One question for the experts, can you test the preload of your kingpins with the removal of the brake disk and rear wiper seals with just the CV and front dust guard in place?
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!!....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
timmay556 (26th June 2019)
Thanks mate. you are super helpful.
Cheers
MudRunnerTD (26th June 2019)
Thanks for taking the time of putting this up
MudRunnerTD (18th August 2019)
Great info. Thank you champ.
I’m going to be doing the wheel bearings on GU this weekend. I saw a vid by terrain tamer where he tensioned the wheel bearings then he hit the edges of the tyre with a sledge Hamer then checked for movement. Which there was then he tightened them again.
Is that a good method of seating them????
Any ideas would be great. Cheers
Last edited by Rustyno1; 21st August 2019 at 08:53 PM.
MudRunnerTD (18th August 2019)
Thanks for the detailed step by step with pics. Much appreciated
Just to add more clarity the copper washer all so needs greasing
Thanks Heaps Mudrunner ,,just made the whole job that much easier!! appreciate it!