-
23rd June 2014, 01:50 PM
#1
Patrol Freak
-
The Following 10 Users Say Thank You to jff45 For This Useful Post:
AB (23rd June 2014), Bloodyaussie (23rd June 2014), Clunk (24th June 2014), jack (23rd June 2014), MudRunnerTD (23rd June 2014), NP99 (24th June 2014), rkinsey (24th June 2014), Sherro (8th October 2014), tikashooter (23rd June 2014), twisty (25th September 2014)
-
23rd June 2014 01:50 PM
# ADS
Circuit advertisement
-
23rd June 2014, 11:54 PM
#2
Advanced
Nice work.. Wish I was handy with the welder.
2009 ST-L with a few goodies.
-
-
24th June 2014, 12:01 AM
#3
Legendary
1999 GU 4500 dual fuel
Il dado è tratto
-
-
24th June 2014, 09:13 AM
#4
Patrol Freak
-
-
24th June 2014, 09:20 AM
#5
Legendary
great job mate cant eeight to see it all togeather
2007 GU 6 /ST-L / MYO8 / DIESEL/AUTO /MOONSTONE /pro vent 200
OH LEATHER IS NICE
-
-
24th June 2014, 09:37 AM
#6
Patrol Freak
-
The Following User Says Thank You to jff45 For This Useful Post:
-
24th June 2014, 10:42 AM
#7
Patrol Freak
-
The Following User Says Thank You to jff45 For This Useful Post:
-
24th June 2014, 11:13 AM
#8
Patrol Freak
I ran the solenoid controller wires through the firewall and fitted the original plug under the steering with a small cutout switch.
I also found a momentary rocker switch at Jaycar that's a replacement for the hand controller switch so I mounted it under the dash as a 2nd choice. Could be handy if I break or lose the hand controller.
To finish off, I added a pretty bright LED to let me know if I've left the controller 'armed'..
John
2001 GUII TI 4500 - Now converted to TD42T auto with Nomad valve body
-
The Following 2 Users Say Thank You to jff45 For This Useful Post:
Clunk (24th June 2014), Sherro (8th October 2014)
-
24th June 2014, 11:14 AM
#9
Legendary
Like the solenoid set up near the battery.
Very neat job looks great.
12/97 GEE YOU
4.5lt Gas blower. Lots of mods to come.....all in good time.
-
-
24th June 2014, 11:22 AM
#10
Patrol Freak
I discarded the original TI stainless barwork & bumper and found an alloy bar on Gumtree for $250.
Now to fit the alloy bar and adjust the fairlead.
I did the cutout for the fairlead with an air body saw fitted with a broken hacksaw blade.
.. and no, the rope doesn't hang there now. It was just for the pic
John
2001 GUII TI 4500 - Now converted to TD42T auto with Nomad valve body
-
The Following User Says Thank You to jff45 For This Useful Post: