Jay see 1997 GU build up

[threedogs]

Can anyone recommend a good tyre place that knows what they're doing.

Go see Andrew @ On Track he works on Patrols every day of the week
He even owned a 235 Rwkw comp truck Patrol of course.
Very little he doesnt know about Patrols

[jay see]

Cheers guys.
The km2 M/T is what your talking about yeah?
Ive heard good things from these, but what else do people run. Was thinking of coppers, but after BAs trouble maybe not. Federals, Mickey's anyone tried Achilles?

[nissannewby]

Nittos or toyos.

[jay see]

I'm pulling out the radiator next week to replace the top tank, while mucking around in the shed I found a couple of temp gauges.

1452751712738.jpg

1452751764006.jpg

Problem is that I could only find one sender.

I tried to test by running a wire from the gauge to the sender and dripping the sender in a pot of boiling water. Nothing.
Is there any other way to test before I go and buy a new one.

[jay see]

When putting in a top hose adapter for a temp gauge what is the best position to have the sender. Wouldn't it be more accurate if the sender was facing down.
Would prefer to drill and tap into the housing, has any done this with a tb45?

1453020064570.jpg

Can anyone tell me what is this, can it be removed?

[BigRAWesty]

I know the td42 runs the temp sensor and the glow plug water temp from the thermostat housing, it's to shut the glows off once engine temp is up to a set amount..
Does the tb have a "choke" on it?? Maybe a similar situation?

[threedogs]

Cant you run an Ecu-Talk instead of running guages ??

[jay see]

I know the td42 runs the temp sensor and the glow plug water temp from the thermostat housing, it's to shut the glows off once engine temp is up to a set amount..
Does the tb have a "choke" on it?? Maybe a similar situation?

I worked out that it's the ECU temp sender. Found a thread here from 2012.

Cant you run an Ecu-Talk instead of running guages ??

If not using gauges I would rather use something like this.

http://www.nissandatascan.com/.
Need to look into it a bit more.


Still would like to know where ppl have drill and tapped into the thermostat housing, or if they run the adapter with the sender facing down.

[jay see]

Would this work. Can run both factory and aftermarket sender, both before the thermostat.

http://www.ebay.com.au/itm/321947356...%3AMEBIDX%3AIT

Would there be enough room for the coolant to freely move around?

[Kimbo63]

Would this work. Can run both factory and aftermarket sender, both before the thermostat.

http://www.ebay.com.au/itm/321947356...%3AMEBIDX%3AIT

Would there be enough room for the coolant to freely move around?

There will be no problem fitting a tee I done it for my oil pressure gauge as well go check your local hosemasters,pertek or Enzed