Jay see 1997 GU build up

[10G]

Sent from my iPhone using Tapatalk

Yeh, he's not bad eh MB. I watched his vid to learn how to do my front axle rebuild.

[jay see]

Contact Milweld in Mansfield. That’s what I have and I love it.


Sent from my iPhone using Tapatalk

Has anyone got a contract number for them. I've sent them a Facebook message and an email through their website, but would like to have a chat with them first..

Sent from my Pixel 7 using Tapatalk

[MB]

Sent from my iPhone using Tapatalk

[jay see]

Sent from my iPhone using Tapatalk

Cheers Mark.

I did see that, but wanted to speak to millweld directly. I'll call tvs and see if they can get me through.

Sent from my Pixel 7 using Tapatalk

[mudski]

Has anyone got a contract number for them. I've sent them a Facebook message and an email through their website, but would like to have a chat with them first..

Sent from my Pixel 7 using Tapatalk

5741 9112.


Sent from my iPhone using Tapatalk

[MB]

You’re Too Honest @mudski Brother Mills Mrs is going to Love you
Best to PM & Delete Digits Here Maybe


Sent from my iPhone using Tapatalk

[MB]

@mudski delete post


Sent from my iPhone using Tapatalk

[jay see]

So I picked up a cargo barrier off marketplace for $50. Man what a mission. In the end I had to remove the backing of the fridge cage and work out how to mount the bottom of the barrier. Then make up brackets to mount the top and reposition the electrical components as they now sits higher. A fair bit of mucking around because of the draws, but it's now securely in place. I've had to spin the freezer 90 degrees as it didn't fit.

Managed to also fit a water pump and plumb it to the tank, because of the design it has 2 outlets one on each side. I plumb both sides to one and then to the pump. Didn't quite work, am I asking too much from the pump?

Sent from my Pixel 7 using Tapatalk

[PeeBee]

The diaphragm pump has a poor suction capability, which is why they only rate the discharge head. You will do better lowering the inlet of the pump to the same level as the tank outlet, then it should work fine.

[jay see]

The diaphragm pump has a poor suction capability, which is why they only rate the discharge head. You will do better lowering the inlet of the pump to the same level as the tank outlet, then it should work fine.

Thanks.

I did try it at a lower level, but probably not long enough to get the air out. It was late and I was getting impatient I will give it another go on the weekend. The bloody shopping trolley is playing funny buggers, just out of the blue it gets irregular revs then stops, starts up fine and keeps going. Did it twice this morning within 15k out of a 45k trip. Ahhh,

Sent from my Pixel 7 using Tapatalk