-
17th October 2013, 05:16 PM
#1
Beginner
RD28T to RB30 conversion
Hey, looking at doing a conversion on my 1996 diesel patrol. As it's been giving me a bit of grief for sometime and cost a few $$$$$ I'm looking at the RB30...! Just wondering what would need to be changed, any problems, anyone who has done the conversion! Any help will be appreciated!ImageUploadedByMotorculture1381988747.128323.jpg
-
-
17th October 2013 05:16 PM
# ADS
Circuit advertisement
-
17th October 2013, 06:47 PM
#2
Are you considering a rb30s - carby, or going efi?
The gear boxes / bell housing are supposed to be the same.
If you go RB30s - the wiring will be simple.
The coil pack is mounted on the mot
When I put a rb30 into mu MK, I used Enzos to make a power steering hose
1991 GQ LWB 4.2 Carby dual fuel, 32 mud claws, 2 inch lift, LSD's front and back
And its Toooooooo High for the Ball & chain
-
The Following User Says Thank You to GQ TANK For This Useful Post:
Tonka_PatroL96 (17th October 2013)
-
17th October 2013, 07:46 PM
#3
Beginner
Ummm I'm not too sure yet..... Most likely the EFI, just doing some research to figure out still....! Cheers though
-
-
20th October 2013, 04:50 PM
#4
If you go efi - get a complete skyline setup - the looms are easyier to use.
1991 GQ LWB 4.2 Carby dual fuel, 32 mud claws, 2 inch lift, LSD's front and back
And its Toooooooo High for the Ball & chain
-
-
22nd October 2013, 06:26 PM
#5
Beginner
Oh really???? Is there plenty of length on the skyline loom??? Or isn't the length a problem
-
-
10th July 2014, 10:16 PM
#6
hello i have a nissan patrol td6 rd28eti2 engine.. it can not run.. i had to change the fuel pump and the injectors cause of bad fuel was put in. the pump shoots out fuel out of the pipes and still it will not run.. need help and to know the firing order and where is number one cylinder is it at the front or at the flywheel. and the pump it self it has a,b,c,d,e,f is a goes to number one..
-
-
15th July 2014, 07:52 PM
#7
clintrv - I would do a new the post under engine mechanical - as this post was about replacing the rd28t with a rb30.
One of the guys with a rd28 may notice the new post and respond. - sorry I have a tb42.
Also once you have 20 posts you can download the manuals.
1991 GQ LWB 4.2 Carby dual fuel, 32 mud claws, 2 inch lift, LSD's front and back
And its Toooooooo High for the Ball & chain
-