Wanted: GU Ute gearstick surround and passenger seatbelt.

[P4trol]

G'day,

I'm part way through converting from bucket seats to the 3/4 bench seat. I am chasing the following parts:

The passenger retracting seatbelt
Gearstick surround

Both from a Ute. The female end of the seatbelt from the Ute takes a different seatbelt tongue to the wagon I have.

[my third 256]

try this mob
http://www.nisswreck.com.au/

[Cuppa]

G'day,

I'm part way through converting from bucket seats to the 3/4 bench seat. I am chasing the following parts:

The passenger retracting seatbelt
Gearstick surround

Both from a Ute. The female end of the seatbelt from the Ute takes a different seatbelt tongue to the wagon I have.

I can’t help other than to suggest the obvious - wreckers.
I went the opposite way swapping from the ¾ bench seat to dual bucket seats , centre console etc from an ST ute. The seatbelts were compatible. The handbrake lever was different, as was the gearstick surround as you know. Also the plate around the opening in the floor underneath the gearstick surround was different.

[P4trol]

Ok, second request is if anyone has a pic of their ute with the bench seat out - and is able to point out which threaded holes are used for the 3/4 seat seatbelt anchor points?

And where do the ute crowd put their beer without a centre console?