What has made you Angry Today???????

[mudnut]

Went to mount the ARB lightbar today using the ARB locknuts, after paying the ransom you would think they would actually fit - NOPE, nuts diameter bigger than the slot. So 1 hr on the die grinder, opened up one of the brackets so at least I have the bar security locked from thieving maggots.
I tell ya, when does this shit end?IMG_1849.jpgIMG_1848.jpgIMG_1847.jpgIMG_1846.jpg

With the sub-standard crap that comes with every second purchase, whether it be the wrong part, defective part, or just built wrongly, how does society still function?

[mudnut]

With the sub-standard crap that comes with every second purchase, whether it be the wrong part, defective part, or just built wrongly, how does society still function?

Well!! My run of F@#K S%^ttery continues. Bought a brand new after market washer bottle from , Patrolapart, when I was in Melbourne. Went to install it today. I had already siliconed the two rubber seals and glued the motor housing to the bottle. Through past experience, I have found that the motors can pop out in rough conditions or if being jostled when changing a headlight. Which by the way, another brand new one has already got cracks in it and has moisture on the lens.
Any way, the motors are both leaking out the bottom, from inside. So I'm 380 ks from Lilydale stuck with two leaking bottles!!

[mudnut]

Well!! My run of F@#K S%^ttery continues. Bought a brand new after market washer bottle from , Patrolapart, when I was in Melbourne. Went to install it today. I had already siliconed the two rubber seals and glued the motor housing to the bottle. Through past experience, I have found that the motors can pop out in rough conditions or if being jostled when changing a headlight. Which by the way, another brand new one has already got cracks in it and has moisture on the lens.
Any way, the motors are both leaking out the bottom, from inside. So I'm 380 ks from Lilydale stuck with two leaking bottles!!

Refitted the old washer bottle. On closer inspection, I found the exact defect in the bottom plastic casting on both new pumps, not the motor seal I suspected. I bet the whole batch is defective. Tried sealing both with silicone rubber. Only time will tell if it works.

[PeeBee]

Refitted the old washer bottle. On closer inspection, I found the exact defect in the bottom plastic casting on both new pumps, not the motor seal I suspected. I bet the whole batch is defective. Tried sealing both with silicone rubber. Only time will tell if it works.

Go back to PAP, they should warrant this Craig.

[mudnut]

Go back to PAP, they should warrant this Craig.

760k round trip. I'm on it!! Actually went to ring them but they were at lunch. Will try tomorrow.