-
18th March 2019, 09:33 PM
#13301
Daily Lurker
Watched the movie Stan and Ollie. A movie portrayed about true friendship and loyalty. Best movie I've seen in a while.
Sent from my SM-G930F using Tapatalk
-
The Following 2 Users Say Thank You to rusty_nail For This Useful Post:
MB (20th March 2019), TPC (20th March 2019)
-
18th March 2019 09:33 PM
# ADS
Circuit advertisement
-
20th March 2019, 06:45 PM
#13302
.........
-
The Following 2 Users Say Thank You to MB For This Useful Post:
Bidja (20th March 2019), Clunk (21st March 2019)
-
20th March 2019, 07:22 PM
#13303
Patrol Freak
Looking schmicko there Mark. Should come up good deep colour too.
Traversing Ban Saw, on skid rails and how does it run thru (push frame or winch)?
2008 GU WAG ST Manual CRD - To do the job
-
The Following User Says Thank You to Bidja For This Useful Post:
-
20th March 2019, 07:43 PM
#13304
Daily Lurker
Nice work mate, I would probably hit it with a belt sander first though? Your likely to kill that poor little sander lol. The Ransome orbital will do the finishing touches but the belt will do any hard work and save time. Welcome to borrow mine for comparison v just the orbital if you like.
Sent from my SM-G930F using Tapatalk
-
The Following User Says Thank You to rusty_nail For This Useful Post:
-
20th March 2019, 07:47 PM
#13305
.........
-
The Following User Says Thank You to MB For This Useful Post:
-
20th March 2019, 07:49 PM
#13306
-
The Following User Says Thank You to MB For This Useful Post:
rusty_nail (20th March 2019)
-
20th March 2019, 08:13 PM
#13307
Daily Lurker
Originally Posted by
MB
Top advice truly, thanks Nick
Sent from my iPhone using Tapatalk
No need to spend big bucks on a Milwaukee one either mate, just go a budget trade brand like the maktek, this will tough it out through most of what U need mate.
https://www.totaltools.com.au/109060...hoCMgkQAvD_BwE
Sent from my SM-G930F using Tapatalk
-
The Following User Says Thank You to rusty_nail For This Useful Post:
-
20th March 2019, 08:24 PM
#13308
.........
-
The Following User Says Thank You to MB For This Useful Post:
-
20th March 2019, 08:59 PM
#13309
Daily Lurker
-
The Following User Says Thank You to rusty_nail For This Useful Post:
-
20th March 2019, 09:02 PM
#13310
Daily Lurker
Originally Posted by
MB
There you go again good mate, trying to convert me and others across to Makita
hey its not my fault everyone wanted a go at the 36v chainsaw lol
-
The Following User Says Thank You to rusty_nail For This Useful Post: