Falcon xr seats into gq

[lg 91]

Well as the title says I've installed a set of ba/bf xr front bucket seats to my gq so here's abit of a write up on how to do it.


First off all get the xr seats and remove the original rails these are not needed.

Then remove the seats from the gq and remove the rails from seats I put the rails back in so I could work out the hights of the rails.

The outer rail needs to be raised 25mm I used abit of shs



Then notch the shs to suit the rail and drill holes to Match




Then drill a hole in the original bracket to suit the xr seat



Then you need to modify the inner rail as its about 50mm to short I just made a plate to fit the full length of rail



Then I attached the plate through the original real hole and drilled a new one to suit in the plate then you have all the holes were u need them for new seats.


Then we come to the seats them selfs when I put them in they were touching the pillar you could modify the rails to move over about 30mm but I did something different I swapped the seats around so iam using the passanger side for drivers and so on then you have enough room for all the adjusters of the seats

To make the seats look right remove the plastic panels and swap them around


Then drill this one out 30mm so the adjuster fits



Than bolt the seat down and ur done





I still haven't done the passanger side but should be simaller to the drivers but ill post some pics if any things different

Enjoy the comfort