-
2nd June 2013, 06:31 PM
#1
Expert
Rounded exhaust bolts ( dump pipe )
Hi Guys
Got a question. I had epic fail time trying to remove exhaust bolts underneath the car. I managed to round off one nut .
How can i get his nut off ? I have 3 to remove altogether . I tried spraying with CRC . no luck. none of these nuts are budging
-
-
2nd June 2013 06:31 PM
# ADS
Circuit advertisement
-
2nd June 2013, 06:51 PM
#2
Hardcore
You could crc , blow torch to heat them don't use a shifter on them if that's how you rounded it use a spanner or socket set. Are you planning on puting the exhaust back on??
IF ITS NOT BROKEN IT MUST BE A PATROL
-
-
2nd June 2013, 07:00 PM
#3
Expert
yeah i was using socket . but it slipped. blow torch i see. i was at the Sunday market today , Guy was demonstrating a blow torch with those gas cans . Should've got one ! . also would a heat gun work ??
i'm trying to remove the dump pipe so i can get the egt gauge bung welded on.
-
-
2nd June 2013, 07:05 PM
#4
Hardcore
I'm not sure if heat gun will work it might let me know if it does heat does work well on stuck nuts and bolts etc best advice is just keep going at it you'll get it eventually
IF ITS NOT BROKEN IT MUST BE A PATROL
-
-
2nd June 2013, 09:11 PM
#5
Legendary
Try using a 6 hex socket, did you use a 12 hex? Also apply some butane heat as you discovered already.
1999 GU 4500 dual fuel
Il dado è tratto
-
-
2nd June 2013, 09:17 PM
#6
Patrol God
Spray them again then again before you quit for the night
let the crc wd40 soak in over night
-
-
2nd June 2013, 11:24 PM
#7
gas axe... works a treat with those stubborn bolts
-
-
3rd June 2013, 12:28 AM
#8
..........
You could try a Metrinch socket, can work with rounded bolts.
http://www.metrinch-tools.com/
-
-
3rd June 2013, 10:21 AM
#9
Patrol Freak
Failing all that - go to a good tool shop and buy a nut cracker. They simply attatch to the nut and split it in half.
http://www.tooldesk.com/automotive/K...-Splitter.aspx
-
-
3rd June 2013, 10:23 AM
#10
Patrol Freak
you are talking about the bolts at the bottom of the dump pipe if so just cut them grinder or gas axe will do if at the top behind the turbo belt a socket on if that fails it is a removable stud so it can be cut
07 crd,,bridgestone 697lt, 2.75 buedesert ex,
SOLD theres a lot of my blood, sweat and money in that troll.
92 gq ti tb42efi my brothers gq extractors dual batteries brake controller uhf alloy bullbar
SOLD with a heavy heart but gone to a nice young fella
13 y62 the beast that burbles
-