OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

User Tag List

Results 1 to 1 of 1

Thread: Y60 Window regulator replacement

  1. #1
    Beginner
    Join Date
    Mar 2012
    Location
    Bald Hills, QLD
    Posts
    28
    Thanks
    8
    Thanked 1 Time in 1 Post
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Y60 Window regulator replacement

    Hi All,

    Had to replace the nearside (power) window regulator on my Maverick.

    Job wasn't too hard , even for a newbie like myself. $30 next day delivery...sweet !

    But...

    The window tilts forward when going up, meaning it wont sit in the rubber channel ( leaves a gap in the top rear corner) unless guided in by hand.

    The manual says that I need to loosen a couple of screws, fit the glass into the correct position ( top rear corner in tight) so that the glass runs inside the groove and then retighten.
    When the glass is fully up & in position , I can't access the screws to tighten them.

    An old review of the Y60 says that the window regulators are a weak point, so I'm sure a few of you have replaced them.

    What am I doing wrong ? How can I get the rear of the glass to stay in the groove ?

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Location
    Advertising world
    Posts
    Many

     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •