Results 1 to 2 of 2

Thread: ZD30 Gu Patrol

  1. #1
    Beginner
    Join Date
    Feb 2013
    Posts
    28
    Thanks
    0
    Thanked 3 Times in 3 Posts

    ZD30 Gu Patrol spool Up Rate

    Hi all,

    Chasing some information, I have just installed a gen Garrett Turbo to my ZD30, and taken if for a run. I must say its a 100% improvement on the original, anyway It lacks power i mean the turbo does not spool up until the revs hit 2750 rpm this was the same with old turbo.

    After reading some of the forums and seeing turbos spooling up at 2000 rpm i am guessing i have another problem or is this only being achieved after completing the EGR mod, as i am wait on the dawes value and 3 inch exhaust to arrive.

    PS
    at the moment with the new turbo installed i am showing 14psi @140 kph with no mods but the spool up rate i would like to start at around 2000rpm

    any help or suggestions here

    regards
    Last edited by Gu01patrol; 2nd February 2013 at 10:17 PM. Reason: heading

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many

     

  3. #2
    Patrol God threedogs's Avatar
    Join Date
    Jun 2012
    Location
    Melb
    Posts
    17,936
    Thanks
    3,976
    Thanked 4,165 Times in 3,317 Posts
    Hi mate Might want to pop over to the intro section first.
    Its just something the forum asks of all new members
    You'll get a much better response as well, Cheers
    04 ST 3lt auto,I have NADs,Diesel Smart tigged Intercooler + ARE scoop, TJM snorkel, DP chip and 3"Zorst, GPS tracking sys, in dash TV, GPS.Blue tooth. Cruise control, 240watt light bar, awning, Outback side steps, DVR, 100watt HID driving lights, internal spare wheel, Faux wheel on rear door. heated Stratos driver seat with lumbar, custom roof rack, well set up tourer, F + R recovery points. Warn 9.5 XP winch with Dyneema rope.Dimmple drilled and slotted rotors

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •