-
16th January 2013, 05:13 PM
#21
Beginner
Disclaimer
YOU DO THIS AT YOUR OWN RISK.
Don't blame me if your wheel falls off, your bearing seizes, etc.
I have not included torques etc as you should have a workshop manual to look up the correct torques etc.
This thread is intended to show how simple it is to do this modification.
Have fun.
-
-
16th January 2013 05:13 PM
# ADS
Circuit advertisement
-
16th January 2013, 05:21 PM
#22
Beginner
Originally Posted by
threedogs
Great pics too good in fact, whats your next thread recoeing rims, I'd be giving them a light sand and a can of spray IMO
Maybe after I finish this
Effii gets rebuilt
Needed to adjust the wheel bearings before we head of to Flinders Ranges end of next month, so thought I'd do this at the same time.
Originally Posted by
threedogs
Did you re use old hub gasket, new one any RTV required???
No gasket at all. Used a light coat of Aviation Form-A-Gasket buy itself. The hubs did not have gaskets in them when pulled and do not look like they've ever had gaskets. No water or dirt issues (did Kimberley to Nth Qld, via GRR, Nathan River Road, etc mid last year).
Last edited by 4x4falcon; 16th January 2013 at 05:23 PM.
-
The Following User Says Thank You to 4x4falcon For This Useful Post:
threedogs (16th January 2013)
-
16th January 2013, 05:30 PM
#23
Patrol God
Thanks 4x4 falcon just picked up two x 8mm hex with 1/2" drive sockets for $16 just for this very job.[Ebay} one I'll leave in 4x4 just in case other in tool kit at home
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
-