Patrol..

[mudski]

On your lift. by the receipt I have from when the OME 2inch lift was installed it says...

• front left pre fitment : 750mm
• front right pre fitement : 755mm
• rear left pre fitment : 785mm
• rear right pre fitment 779mm
• front left post fitment 804mm
• front right post fitment 807mm
• rear left post fitment 843mm
• rear right post fitment 843mm

all measurements taken from bottom of guard to lower section of the rim. 16inch rim too.

[meh]

Few pics from the weekend. My mates GQ makes mine look like it isnt lifted

[Davey Jones]

You can figure out the lift by measuring the bump stop heights.
I think the superior website has all the stock heights. just measure yours and compare.
Nice truck mate

[PattyWgnOwen]

I got some dims off a spec sheet but can't find the link. Stock height at time of compliance for series 1-3 is as follows.
Measurement from centre of wheel to underside of mudguard lip.
Front 555mm
Rear 560mm

I found it easier to work this back to a top of wheel dimension for measuring purposes.

My first patrol sagged more than an inch after a few months but I had quite a lot of accessories so don't expect a 3" lift to be 3" if you have a heavy 4x4 especially if it's a td42???