My Rear Drawers

[Stropp]

Well done mate, you don't have the measurements do you, I need to make a set for mine.

[ozzyboy]

nice set mate. love your work

ozz

[waz65]

Well done mate, you don't have the measurements do you, I need to make a set for mine.

Thanks Stropp , they are about 1100mmW , 950mmL and 280mm high

nice set mate. love your work

ozz

Thanks mate

[Stropp]

Thanks Stropp , they are about 1100mmW , 950mmL and 280mm high


Thanks mate

Thanks, gotta have a go at some myself.

[mtnranges]

Awesome!! that has given me a few ideas. Thanks for posting

[MYR1G]

Hey Buddy,
Love the drawes,going to start building some on saturday,just unsure about the sliders,how did u make them not pull out all the way?also is there a way you can pull each drawer out after there installed?
good looking build!!
Cheers Jake

[butternut99]

how did you fit the draws to your patrol

[waz65]

Hey Buddy,
Love the drawes,going to start building some on saturday,just unsure about the sliders,how did u make them not pull out all the way?also is there a way you can pull each drawer out after there installed?
good looking build!!
Cheers Jake

Thanks mate , I used 25x25 box tube and bearings for the drawer sliders , I got it so the drawers come out about 3/4 , I have a length of flat steel bolted to the end of the drawers this hits a small peice of 25mm angle which is attached to the drawer frame .
all it takes is 2 screws to take the 25mm angle off which then allows the drawers to come completely out ( hope this makes sense )
cheers
waz

[waz65]

how did you fit the draws to your patrol

I got longer bolts to suit the existing tie down points in the cargo area and used them

[MYR1G]

Thanks mate,
Ahh such a simple way,was trying too work out for ages hahah!!!,was going to buy some sliders but the bearing option seems cheap,stronger and best of all SIMPLE!!!One last question,what thickness timber did u go with?
Thanks,Jake