ARB dual battery tray install, GU IV 4.2 TDi

[Rip'n'Shred]

I am installing a ARB dual battery tray in my GU IV 4.2 TDi.

I am unsure of where the coolant hose from the header tank to the thermostat housing is supposed to be relocated. I pushed it out of the way around the tray but it doesn't seem right. (sits along tray on turbo side).

Has anyone got any ideas of a pic our two of their setup.

I would also love to know how the hell you get your hand and then a spanner up inside of guard to attach top section of tray to inner guard.

[my third 256]

hose is ok
you should have got a long bit of steel about 30cm long 10 mmwide and a squate hole on end with a special nut that fits into it
poke it up from the front of the guard, corner of the bonnet ( top of guard by light )
align bolt then break of exess stell all done
stephen

[Rip'n'Shred]

Thanks mate. Your spot on. I rang ARB after reading your reply and they did miss it out.

Still not too happy with the hose, I might wrap an old hose around it where it touches the tray.