Rear Light Kits

[cambo]

Anyone found a kit to get the redundant rear lights working ?
My next project is calling.

[dan&tamspatrol]

http://www.ebay.com.au/itm/Nissan-GU...item5891570ed8

try these if you want to look ur self put gu patrol lights into the ebay search bar

[paulvdw]

Just found and purchased these Nissan GU 4 04-10 Patrol New TailLights FULL Functions! from www.carsrus.com.au.

$155 for a pair and wiring harness.

Hopefully they do the job. will feedback when i recieve them

[altech]

Hi Paul, I have same tailights from ebay , yes there are ready to go for fitting ,passager side just plugs in , but driver side on my Ti 98 I had to do some wiring as there nothing there to connect , which was ok as there a rubber gomit just below the inside of rear cabin that you can feed the stop/tail and blinker wires from the bumper lights harness, hope this helps . cheers Alex p.s. lens unit do have big slot globes ,the same sharp as dash light globe , hmmm

[mudski]

Just found and purchased these Nissan GU 4 04-10 Patrol New TailLights FULL Functions! from www.carsrus.com.au.

$155 for a pair and wiring harness.

Hopefully they do the job. will feedback when i recieve them

The wiring harness they are talking about would be the wiring shown on the back of the light. I doubt it would be the actuall harness itself which is needed for the earlier trolls. I'm looking at doing the same as it's got me beat why they go to the trouble of making a car with dummy lights in it... But I am thinking of stopping past the wrecker and getting the actual rear harness assemblie of a later model car so its all done properly. I really just CBF'ed making one up.

[scotty83]

Hi Paul, I have same tailights from ebay , yes there are ready to go for fitting ,passager side just plugs in , but driver side on my Ti 98 I had to do some wiring as there nothing there to connect , which was ok as there a rubber gomit just below the inside of rear cabin that you can feed the stop/tail and blinker wires from the bumper lights harness, hope this helps . cheers Alex p.s. lens unit do have big slot globes ,the same sharp as dash light globe , hmmm

I ran them across the back door. Under the carpet and plastic strip. saved me having to go outside through grommits.

[cambo]

Thanks guys - Has anyone done this on 09 GU - as i haven't checked if the original harness plug is still there, I would think it should be just haven't checked yet.

As musdski said i might also see if a late model nissan has the same connector then i could just modify to fit a patrol.

[altech]

I ran them across the back door. Under the carpet and plastic strip. saved me having to go outside through grommits.

Hi Scotty, I did that for the reverse light , did you connect the right side blinker as had got that wire from bumper cheers Alex

[hekarewe]

Just found and purchased these Nissan GU 4 04-10 Patrol New TailLights FULL Functions! from www.carsrus.com.au.

$155 for a pair and wiring harness.

Hopefully they do the job. will feedback when i recieve them

i got mine from carsrus over 12 months ago and they are great work a treat and good value for money.

[oncedisturbed]

I need to look at something similar but would need an aftermarket "Y" frame wiring harness made up to plug into OEM wiring so that the tail lights and the bottom set on my kaymar bar together