Well i am going......
Type: Posts; User: 97_gq_lwb
Well i am going......
I had something similar it was a stone between the disc and backing plate.
This has become the fully shick bro oh my god sheriously thread .
When i did monza seats i used a 10 mm thick plate the one in the center of the pic below to level them out.
http://i567.photobucket.com/albums/ss117/it250k/patrol061.jpg
If anything like mine the...
I would say you need a fair bit more fuel mine was wound in before i even fitted the turbo then i wound it in even more .
I had to turn the idle screw back out a fair bit as well once i wound...
looks a little like a condensor near your coil usually i think lol it's been a while.
All done now will give it a bit of a test tomorrow and see how noisy it is.
The plate i used to level out the seat was 10mm thick other then that no but if you look and compare bolt holes etc it will give you a rough idea and make it a bit easier..
If your recovering a monza seat i would recommend trimming down the side supports as they get crushed real quick getting in and out.
I made some brackets and took pics it will give you an idea...
gy and sb green yellow sky blue go to the speedo
Yes of course i do the dices on the mirror took 2 seconds off my 3 minute quarter mile.
But the fancy blue wiper arms gave me 5 seconds.
by chroming the grille i was able to achieve a 2.50 minute...
Double standards i think ab should do the right thing and take away their privileges altogether and give them all a 2 week ban lol
:animierte-smilies-f:animierte-smilies-f:animierte-smilies-f:animierte-smilies-f Oh my god whats next bro a fully sick lowered patrol with 22 inch chromies seriously.
I think growlers is preparing himself for owning a gu .
Does it have point's or pertronix ? if points it may be the condensor and points just replace them with a pertronix anyway money sell spent.
Try disconnecting the noise suppressor.
Check for any...
Ok your turbo has a threaded rod coming off the actuator.
How it works is that arm pulls tight closing off the wastegate as boost rises it pushes the arm out opening it up.
So by making that arm on...
well anyone using the l.e.d lpg gauge will know how useless they are.
Years ago when i had a petrol gq i wired mine up to the one in the cluster.
It worked great and didn't jump all over the place...
Have you adjusted the waste gate on the turbo that's what controls your boost..
And just wind the fuel screw in some more .
Basically more fuel more power then more boost will help it burn and ...
Put in a paypal claim 9/10 times they respond straight away when i do it.
It's funny though they ignore all the ebay messages but the second you go through paypal they answer lol.
New exhausts stink for a while as well especially if they have painted them on the joins etc.
Might pay to check the bungs in the floor as well.
Well it is halfway in i did use the torque wrench when i did mine refer to the manual for the torque specs .
It is a straight forward job quite simple and easy to do nothing i found frustrating the...
I have one of those low pressure electric fuel pumps on the side of the battery tray their are threaded bolt holes that line up perfectly.
Sounds like you need to wind the fuel up some more.
I run...
Got half way through a spartan locker install.
What else did they do though.
He is talking about a td42 standard pump with a turbo fitted.
What is your setup ? does it have a boost compensator did they change pump timing or anything else...
Ok looking at the controller it appears to be like the earlier td42 one just 24 volt.
The double glow relay is a bit confusing can you take off the air box or get the camera in and take a shot of ...