OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Type: Posts; User: Cremulator

Page 1 of 7 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    8
    Views
    184

    I recently fitted a Jaylec 125A alternator (part...

    I recently fitted a Jaylec 125A alternator (part number 65-3124-1) to my 2004 GU III TD42.
    I chose a slightly uprated one as I had installed a dual battery setup.
    That's the first alternator I've...
  2. Hey @MB, did you sort this out? I was just...

    Hey @MB, did you sort this out?
    I was just reading through the operating instructions for the redarc G52-BET and thought you could use the optional temp warning level on your redarc gauge to trigger...
  3. Replies
    9,225
    Views
    806,900

    Good one @MB, it's a simple thing to check and...

    Good one @MB, it's a simple thing to check and replace if needed [emoji106]
  4. Replies
    11
    Views
    241

    If you haven't bought a catch can yet, have a...

    If you haven't bought a catch can yet, have a look at the flash lube pro. They are a bit more compact than the provent.
    https://www.flashlube.com/en/products/catch-can-pro.html
    This is what I...
  5. Replies
    11
    Views
    241

    Not to derail this, but is that an Anderson plug...

    Not to derail this, but is that an Anderson plug for charging your dual battery via solar in the bottom right of frame?
  6. Thread: My gu tub

    by Cremulator
    Replies
    4
    Views
    157

    Ah gotcha, I want sure what the donor car was...

    Ah gotcha, I want sure what the donor car was [emoji106]
  7. Thread: My gu tub

    by Cremulator
    Replies
    4
    Views
    157

    Is that a Mitsubishi Triton rear tub? Because the...

    Is that a Mitsubishi Triton rear tub? Because the one in the top photo looks like a Navara rear tub to me.
  8. So that was using the 88c or 82c thermostat @MB?

    So that was using the 88c or 82c thermostat @MB?
  9. Replies
    11
    Views
    410

    While we are on this, what are the torque...

    While we are on this, what are the torque settings for tightening wheel nuts?
    And would those torque numbers be different for alloy vs steel rims?
  10. Replies
    9,225
    Views
    806,900

    Yeh I had no idea about this potential issue...

    Yeh I had no idea about this potential issue either. I just opened up the air box to inspect the filter and give it a clean and saw some large black fragments in there. Turned over the lid and found...
  11. Replies
    9,225
    Views
    806,900

    Replaced the seal in my air box. There was only a...

    Replaced the seal in my air box. There was only a small piece of the old seal left in the lid and a few shall pieces in the air box. Very hard and brittle....
  12. Replies
    13,967
    Views
    1,112,132

    Sticky: (From the 'what has made you angry today?'...

    (From the 'what has made you angry today?' thread)


    Just received notification in the mail. Infringement withdrawal notice and official warning.

    As you could guess, I'm more than happy right...
  13. Replies
    137
    Views
    51,530

    Sticky: Sure is! [emoji6]

    Sure is! [emoji6]
  14. Replies
    3
    Views
    175

    Mighty car mods did a video recently on...

    Mighty car mods did a video recently on re-skinning door cards if your want to give it a go yourself.
    https://youtu.be/nXSEy4AFQas
  15. Thread: Fuel system

    by Cremulator
    Replies
    6
    Views
    260

    I might have spoken too soon on the sub tank...

    I might have spoken too soon on the sub tank light fix. After a short drive today it's come back on.
  16. Replies
    9,225
    Views
    806,900

    I'll be listening to your results with interest...

    I'll be listening to your results with interest as a tune is the next thing on my list.
  17. Thread: Fuel system

    by Cremulator
    Replies
    6
    Views
    260

    That's good to know that the sub tank pumps a...

    That's good to know that the sub tank pumps a little each time you start the car under certain circumstances.
    Hodge I filled the sub tank when we went camping last year and haven't been using the...
  18. Thread: Fuel system

    by Cremulator
    Replies
    6
    Views
    260

    I just had this issue with the sub tank light...

    I just had this issue with the sub tank light staying on three days ago. I disconnected the main battery for 10 minutes and the sub tank light stayed off when I started the car the next time.
    Thanks...
  19. I did notice that those clips had a hinged part...

    I did notice that those clips had a hinged part at the base. That's great that it's a locking function.
  20. Ben, what's the reasoning behind having a quick...

    Ben, what's the reasoning behind having a quick release clip vs a fixed buckle?
    These look similar to the straps I repurposed from old child care seat extension straps to hold my fridge. They have a...
  21. I'd be interested in these straps too. They look...

    I'd be interested in these straps too. They look the business.
  22. Replies
    13,967
    Views
    1,112,132

    Sticky: Sorry for your loss. What a generous and...

    Sorry for your loss.
    What a generous and empathetic gesture he made with his purpose built house.
    These are the kinds of people who can inspire long after they're gone.
  23. Replies
    8
    Views
    224

    Springing these kind of changes on users is why I...

    Springing these kind of changes on users is why I backup my apps before updating and only update sporadically.
    I'm using Tapatalk 8.1.8 and can still upload multiple images. The current version is...
  24. You should not lose any emails as they are most...

    You should not lose any emails as they are most likely stored on a central server that your desktop and phone booth access (when you read an email on one of those devices you should see it becomes...
  25. Thanks everyone for the responses. I'll buy the...

    Thanks everyone for the responses.
    I'll buy the redarc temp sensor and most likely monitor water temp.
    For anyone who has one of these sensors, is it a 1/4 NPT or 1/8 NPT thread that's needed? Or...
Results 1 to 25 of 169
Page 1 of 7 1 2 3 4