Thanks Alitis007
Who cleaned your tanks?
Type: Posts; User: zmaster
Thanks Alitis007
Who cleaned your tanks?
Thanks for responses!
Have a long ranger main tank, but was hoping to save aux tank. Will give the electrolysis a go, could take a while but then have nothing to loose. Will set up power supply in...
have opened it up through sender and found baffles on both sides, can only access a small area.
Hi All,
Pulled out my aux tank and found a layer of rusty crud on the bottom. Natrad offered to clean the tank for between $250 and $500, still better than the $1100 for a new one. They claim they...
Awesome job, wanting to do the same on the GQ, have the pod just can't work out how to get the wiring neat, it's a lot of wires.
Time for a new sub tank. The current one is about 60L square type, without the wing extending over the axle, and I want to replace with the same as I have adjustable upper arms and don't want to...
Sorry, 97 TB42E Auto
Hi All
Have just pulled out the LPG tank and am in the process of fixing all the butchered wiring around the engine bay. At the rear of the truck there is the original wiring loom for the fuel...
I'm thinking the same!
Thanks for the brilliant response, I was also thinking temp sender,will measure the TPS and IAC, have ECU Talk, and laptop, temp seems to be reading fine, not sure how high it should climb, can't...
idle has always been high. Vacuum is good, will chech TPS, remember reading about Temp sender could be cause?
As the title suggests, my Gq TB42E auto, has a high idle, was at 1100rpm in neutral, using the screw in the back of the manifold, i've dropped it down to 950rpm. Should I keep winding the screw until...
Sounds like a plan, thanks!
Decided to remove the LPG from the GQ and fit long range tank. Anything I need to know? Do I just remove everything non standard?
So after raising the truck, I noticed the tailshaft gets real close to the crosmember on full drop. Simple enough, just remove the tailshaft and flip it! Well, good luck, the yoke seems to have...
Thanks for responses, has good spark, fuel pressure just under 300 at idle. Will check each sensor manually tomorrow, ECUtalk tells me all good with fuel, timing, O2 etc. Not sure what injector %...
Only legislation in NSW, is that items meet ADR by being securely bolted down in cargo area, and even then, only an issue if you are selling the product and claim it meets ADR. Stricly speaking, you...
Old girl has been getting harder to start . Its a TB42 efi and gas, on start up, very slow to fire and then starts at about 300rpm and slowly works its way up to a750rpm. Thought it might be dodgy...
The manual here only covers up to TB42s, need wiring diagram of thermo switch on A/C thermo fan. Damn thing has never come on, fan works fine when wired straight to power. Also want to look at efi...
Had thermos in the past, found the mechanical fan more reliable and sucked more air!
Its probably floating around somewhere, but does anyone have a copy of the TB42E factory service manual supplement? Would appreciate any advice on finding a copy.
Need some advice on rebuilding a sealed viscous fan clutch out of petrol Patrol. Have searched all over the net, numerous forums, on rebuilding a fan clutch. There are comments of drilling holes and...
Just discovered three more switch blanks behind the coin tray in the GQ today, had the truck for years, who knew? Is there anything these trucks can't do?
Hi all
Need some info on TB42 fan clutch. I need to add some oil in the fan hub. Can you open them? There's probably a thread here somewhere but can't seem to find it. Any tips would be appreciated.
I've got the windcheater alloy rack, brilliant rack, flexible and tough as. Lots of slots for mounting brackets, easy to add custom brackets top and bottom. Heavy duty mounting feet and no rust, no...