Fuel rail connection could be tightened on 3rd line and supply line.
Will check again this arvo. Thanks for the help.
Type: Posts; User: 26PSI
Fuel rail connection could be tightened on 3rd line and supply line.
Will check again this arvo. Thanks for the help.
Checked the fuel line, gave it 30nm and it didn't really move.
cleaned the well, took the car for a drive, not really any leaks.
Did a back leak test, dodgy brothers style. All injectors looked...
Yeah, definitely diesel. I had a mechanic do the rocker cover gasket, maybe he damaged the line/connection. Will check it out this arvo.
Update
Went for a wheel today and had to use a bit of right boot, fair bit more than I should have. Quick once over, and noticed a bit of liquid around the sump. Nothing to serious. Drove home,...
used penrite 10w40 semi synth.
will grab one of those of patrolapart, thanks for the link.
All the info I have seen, pointed me at 10w40. Which I used.
I jacked the chasis up to drain all of the oil out of the sump. The black plastic piece was missing, might have to track one down at the...
It did smell a lot more than the new oil, sweeter, if that makes sense?
where could the fuel be mixing with the oil?
The oil was not the best, thin and frothy, not milky at all. Filter cartridge was loose inside housing, not seated, smaller than the new one.
Not going back to that shop again. Thanks mate.
Been chasing a few issues lately and found an excessive amount of blowby.
Fitted a catch can yesterday and decided to check the oil level. (car is a weekender and have barely put 2000kms since I got...
Found a place that starts at $35k for a 5.9 common rail DIDO engineered for swap only. Any weight issues are yours.
I have been chasing up a conversion place in SE Qld, this place seems to be spot...
installed sound deadener and insulation in doors.
still got the mass noise liner to go before the vinyl goes in.
just googled Energy Polariser, nice!
A little smokier, hard to tell in dark. I'll check in the morning.
Yeah, got rid of the hi-clones.
Don't know what Energy Polariser is?
cleaned the intercooler and pipes today, got a fair amount of oil and residue out.
started it, with a piece of cardboard on the ground to check the exhaust and it was still spitting liquid. But...
80663
80664
80662
some photos, if they work?
had to remove some hiclones as well.
sorry, crank case breather. no catch can installed. was wondering if one would help?
would a catch can prevent this?
thanks for the advice
yeah mate, quite a bit of oil coming from the c/c breather.
Got an issue with oil in exhaust.
Had some electrical issues recently with a faulty alternator, glow plug relay and glow plugs.
Got them all replaced at a mechanics, with the rocker cover gasket...
Yeah, i decided to stick with the clutch after looking around a bit, reading and asking a few opinions.
The original lasted 185k kms, Id be happy to get the same out of the replacement.
Picked up the patrol this morning.
The old pulley had completely let go off the alternator shaft and wasn't generating any voltage at all. Hope it hasn't damaged my batteries too much.
Working away this week, definitely not driving it though.
Booking it in to the mechanics ASAP, just interested in if anyone has used the 110A Hitachi Alternator from Baxters before?
The nut requires a specific spline tool and has been making a noise (shitty bearing, metal on metal).
checked this arvo and sounds rough at start up, missing, smoke when it never had before.
zd30
sorry, I meant the pulley has slid down the shaft.
Almost an inch gap now between the pulley and alternator case.
I had a rattling around that area and after the trip, belt started to...
Hi,
New to the forum and patrols.
I had the alternator pulley shift on a trip last week and thought it would be a good chance to upgrade.
Has anyone done it and come up against any problems? ...