OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Type: Posts; User: nissannewby

Page 1 of 20 1 2 3 4

Search: Search took 0.08 seconds.

  1. Hire one of those carpet shampooers from Woolies...

    Hire one of those carpet shampooers from Woolies next time your there and go to town. Other than that you could try steam clean then a wet vac.
  2. Replies
    9,392
    Views
    875,029

    Around 3000kg. I know my old ute was only 3050 or...

    Around 3000kg. I know my old ute was only 3050 or 3150kg.

    Edit. Had a look at a few on car sales. Appears TD42 wagons were 2800kg gvm.
  3. Replies
    14,380
    Views
    1,247,845

    Sticky: Yeah. It's a gem. 2015 with 7300km on the clock....

    Yeah. It's a gem. 2015 with 7300km on the clock. That's not a typo. Nearly 5 years old with less than 10k on the clock.
  4. Replies
    14,380
    Views
    1,247,845

    Sticky: Nuh we sold that a couple of months ago.

    Nuh we sold that a couple of months ago.
  5. Replies
    14,380
    Views
    1,247,845

    Sticky: Picked up our new ride. A 2015 Isuzu Dmax.79696

    Picked up our new ride. A 2015 Isuzu Dmax.79696
  6. Davies Craig. 80-120lpm pumps. Flow is king with...

    Davies Craig. 80-120lpm pumps. Flow is king with w2a. I would be using the unit that is 25mm lines.

    The last w2a I setup had 1" lines and a Davies Craig 120lpm pump running flat out all the time....
  7. Replies
    230
    Views
    10,309

    There are ways to neaten it up a lot. Throw a PLC...

    There are ways to neaten it up a lot. Throw a PLC and basic screen in and you can run say like 1 can bus cable to the rear to a slave that then can switch on accessories. This kind of stuff is cool...
  8. UFI would be the only pumps I would use...

    UFI would be the only pumps I would use currently. They are constantly getting better at them with the r&d they do. I don't believe there is much difference between their 200hp 11mm or 200hp 12mm....
  9. It's just speculation lol. Both the Patrol and...

    It's just speculation lol.

    Both the Patrol and LandCruiser are at the end of their model runs. They are typically roughly a 10yr cycle. Apart from drawing the y61 out. So we should soon be due for...
  10. It is just an interim face lift will only be a...

    It is just an interim face lift will only be a short production while they are finalising the Y63 model 😋
  11. Replies
    151
    Views
    20,869

    Well the big girl is gone. She went to its new...

    Well the big girl is gone. She went to its new home today.

    Bring on the Y63!
  12. Replies
    9,392
    Views
    875,029

    Filled it with fuel and Washed it. Someone is...

    Filled it with fuel and Washed it. Someone is interested enough they want to put a deposit on it. So the big girl might be gone this week 😔
  13. Replies
    1,962
    Views
    208,686

    The old time traveller Groening at it again.

    The old time traveller Groening at it again.
  14. Around 92 degrees is the sweet spot for...

    Around 92 degrees is the sweet spot for performance
  15. Replies
    8
    Views
    453

    There are loose fasteners on the floor. Some look...

    There are loose fasteners on the floor. Some look to be the shock bush,washer and nut. These need to be installed.....
  16. Replies
    13
    Views
    788

    There is a connector on the bottom of the...

    There is a connector on the bottom of the injector pump on the td42ti engine. It will throw the engine light if there is a problem or its disconnected. Being towards the bottom of the engine they can...
  17. Replies
    230
    Views
    10,309

    The high pressure line will always be the smaller...

    The high pressure line will always be the smaller one. Everything after the steering box should be larger returning to the reservoir with basically no restriction. A cooler helps in that with a temp...
  18. All front Panhard rods have a curve in them...

    All front Panhard rods have a curve in them whether it be GQ or gu. Is the rear one straight?
  19. Replies
    151
    Views
    20,869

    Might hang out until the Y63 comes out....

    Might hang out until the Y63 comes out....
  20. Replies
    151
    Views
    20,869

    Yeah all is fine. Just priorities have shifted so...

    Yeah all is fine. Just priorities have shifted so selling up quite a bit of gear. I will hopefully own another one day.
  21. Replies
    151
    Views
    20,869

    We'll unfortunately I am selling another patrol....

    We'll unfortunately I am selling another patrol. I have really struggled holding onto these vehicles but such is life. Here is a link to the ad if anyone is interested. Will be sad to see it go. It's...
  22. Replies
    230
    Views
    10,309

    Yeah there is just to much flow returning to that...

    Yeah there is just to much flow returning to that little reservoir but it is only a thought. I know BD are fantastic are supplying secondhand crap
  23. Replies
    230
    Views
    10,309

    A standard shaft seal can usually only deal with...

    A standard shaft seal can usually only deal with very little pressure like 30psi or less. Unless a high pressure shaft seal is used. So the hose clamps will still hold on way after there is enough...
  24. Replies
    21
    Views
    1,038

    This guy is not far from my house. I have sat in...

    This guy is not far from my house. I have sat in these seats and spoken to him about a set for the 62. Basically your imagination is the limit for this guy. He had plenty of different styles and...
  25. Replies
    230
    Views
    10,309

    I don't want to seem like a prick but are you...

    I don't want to seem like a prick but are you 100% it's plumbed up correctly? To blow the shaft seal means you are pressurising the case somehow. The shaft seal should basically never see pressure...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4