OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Type: Posts; User: Lieney

Page 1 of 12 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    2,583

    I've been absent for some time, but it's about...

    I've been absent for some time, but it's about time I got back on the forum.
    I have literally just bought a 6bt 12v to put in my patrol. It's a 2011 build complete engine.
    I've heard and seen it's...
  2. Replies
    5
    Views
    1,044

    pm your email• I have detailed feedback from...

    pm your email•
    I have detailed feedback from when I was there.
    Basically 2" without engineer including all types of lift- tyres, body + suspension.
    I tried 3"+35" tyres. Engineer's in Vic wanted...
  3. Replies
    12
    Views
    1,592

    Do a Coolant system pressure test & pull the glow...

    Do a Coolant system pressure test & pull the glow plugs, listen for noise at each as this will tell you where the fault is.
    Could be head gasket, Could be head Could be block.
    Soundslike it could...
  4. Thread: 17000lb winch

    by Lieney
    Replies
    7
    Views
    1,354

    17000lb is overkill in my Opinion. Look at...

    17000lb is overkill in my Opinion.
    Look at warranty, current draw, park, mounting ability + quality etc.
  5. Replies
    6
    Views
    2,444

    As stated. You can have a surge tank that holds...

    As stated. You can have a surge tank that holds excess water for high, or sudden higher rpm. the other is a Overflow to supplement it.
    Hot water takes more room than cold, So it will spit some out...
  6. Replies
    22
    Views
    2,754

    Filling / Priming the fitter is bad practice. ...

    Filling / Priming the fitter is bad practice.
    this can easily allow 'crap'into your pump.
    Better pressurising fuel tank, cranking engine or simply using primer. I assume this works...
  7. Replies
    26
    Views
    3,607

    Agree with macca 86. shiny looks pretty. I have...

    Agree with macca 86. shiny looks pretty.
    I have white flares with rubber flexies to cover the tyre width on my GU IV. I have plenty of scratches from narrow tracks & they show up clearly every wash....
  8. Thread: 2.8 overfueling

    by Lieney
    Replies
    2
    Views
    626

    Raw fuel coming out I'd be looking at injectors,...

    Raw fuel coming out I'd be looking at injectors, as well as the pump. Get ya injectors checked
  9. Thread: New bushes

    by Lieney
    Replies
    10
    Views
    1,720

    Rubber would allow a fair bit of flex within the...

    Rubber would allow a fair bit of flex within the bush, nolothane are much tougher / stiffer and can wear more of the Mounting surface if not a press-fit type bush. Rubber may deteriorate quicker....
  10. Replies
    16
    Views
    4,209

    Mud flap has a distance from the ground. I think...

    Mud flap has a distance from the ground. I think 300mm for off road vehicles
    I'd screw some extra rubber to the side of the flap to please RTA
  11. Thread: Wheel bearings?

    by Lieney
    Replies
    8
    Views
    1,217

    Mate, that is a wiper seal and not bearings. You...

    Mate, that is a wiper seal and not bearings.
    You should have seals that enclose the wheel bearings that are rubber lipped seals.
    I can't remember if the axle has an inner seal, but the oil / grease...
  12. Replies
    54
    Views
    5,382

    At the end of the day, people can only do so much...

    At the end of the day, people can only do so much for free mate.
    An add here or there, if it brings in some $ then so be it.
    I don't use Tappatalk as I am tight and don't want to pay for an app, I...
  13. Replies
    7
    Views
    1,677

    Good point Roofy. If not, when you work on the...

    Good point Roofy.
    If not, when you work on the door, make sure its open as removing the trim is VERY difficult in any car while the door is shut.
    If the mechanism is missing / broken, then get what...
  14. Thread: spot lights

    by Lieney
    Replies
    14
    Views
    1,841

    100W spotlights draw 8.33A each. A total of...

    100W spotlights draw 8.33A each.
    A total of 16.66A will pass through the power and earth side of the circuit and relay.
    A 30A relay with one main input and 2 outputs would suffice.
    Ensure you fuse...
  15. Replies
    1
    Views
    860

    Haven't done it but would consider sorting out...

    Haven't done it but would consider sorting out the neutral start switch that prevents the engine from starting unless in N or P.
    Short it out for the manual conversion, or connect the switch to the...
  16. Replies
    13
    Views
    1,640

    A guide to tyre wear If you look along the tread...

    A guide to tyre wear
    If you look along the tread line of the tyre (from the back to the front over the top of the tread.
    Wear on both outer edges of an individual tyre, all the way around =...
  17. Replies
    4
    Views
    1,047

    Nice rig mate. I would love to lift mine more...

    Nice rig mate.
    I would love to lift mine more than 2, but don't want to pay an engineer heaps of money.
  18. Replies
    12
    Views
    1,536

    Nice looking ride that. :-)

    Nice looking ride that. :-)
  19. Replies
    4
    Views
    805

    Cheers for the info. Wanted to go last year but...

    Cheers for the info.
    Wanted to go last year but didn't make it. Maybe this year.
  20. Nice indeed with the artic and the height. A...

    Nice indeed with the artic and the height.
    A 2.8 with 37's would sound nice, but your rig would really be looking for it's bigger brother.
    Step the diff ratio's up a little and it might be a...
  21. Replies
    7
    Views
    1,294

    Ebay would get you a cheap bar, or Gumtree...

    Ebay would get you a cheap bar, or Gumtree classifieds.
    Tow bar alone would be the cheapest option, but rear bars start somewhere about $1500 and go up from there.
    Unless you make, or have one made...
  22. Replies
    13
    Views
    1,862

    I've seen aftermarket ones $1700 for intercooler,...

    I've seen aftermarket ones $1700 for intercooler, hoses and fan. Very expensive IMO but I have not seen dyno results to see if that sort of coin gives a suitable increase in power, decrease in fuel...
  23. Replies
    26
    Views
    3,283

    Sounds like a 1st gear issue. How's the gearbox...

    Sounds like a 1st gear issue.
    How's the gearbox oil?
    Does it have auto locking hubs? Maybe the hubs (auto or not) are causing issues at lower speeds. Although mine sounded different to what you...
  24. Replies
    13
    Views
    2,152

    Sell it and get a nice bar, that it compatible...

    Sell it and get a nice bar, that it compatible with your winch.
    It'll be easier
  25. Replies
    3
    Views
    1,534

    Quite a few years ago now, but I got an awesome...

    Quite a few years ago now, but I got an awesome deal at Turbo Glide in Sydney / Woolongong for a 2 1/2" exhaust, turbo, injector clean and dyno. At the time it was the cheapest I could get it...
Results 1 to 25 of 286
Page 1 of 12 1 2 3 4